C&C MODELS AERMACCHI BIG L39

Building instructions rev1.0

Pag 1

SERVOS INSTALLATION

All servos bay are ready to accommodate a standard servos,only in the elevatos you must use a

mini servos,we reccomand you to use it with almost 5kg power each side.

To fix the servos in the cover plate,you will find a wood blocks,screw it to servos and glue the

wood block to servo cover,pay attention to align the servo arm to the hole.

For the rudder and elevator you can use a ds3288 or similar servos

Pag 2

In the elevator you must create a hole for the wiring exit.

Before glue the servo horn,protect the aerea behind the hole with a tape.Sand well the Horns in

the bottom side,Mix a small quantity of expoxy resin with fiber filler and glue the horns checking

the correct alignment.

Pag 3

When the glue is dry you can remove the protective tape from the surfaces

Linkage in the kit are ready to use,you only slightly adjust it for a correct 0 position.

Pag 4

Gear doors can be installed usig a hinges like in the photo,for movement you can install the mini

servos.Same situation in the nose door.

Our landing set are ready to fit in the model, only slightly adjustment need.

Pag 5

Small cover must be cutted and screw to the wing

Big door can be fixed to the landing with a simple screw

Pag 6

Fuel tank can be accommodate on the top of the wood plate A.Insert the fuel tank from the

turbine vane before toinsert the inlet ducts.

Pag 7

Inlet duct can be inserted in place without glue,cut the inlet ducts accordling to your turbine

length.Put the turbine more forward possible. Screw the inlet ducts like in the photo.

This metod will help you for any work required around fuel tank and others eqwuipment.

All electronic equipment can be installed in a wood plate on the bottom of cockpit

Pag 8

Inox pipe can be simply screw to two wood block like in the photo

This is the normal setting, you can adjust it around your flight.

SERVOS REQUIREMENT:

Ailerons : 2x6-8 kg standard servo

Flaps:2x12 kg standard servo

Rudder: 6kg mini servo

Elevators:2x6kg mini servo

Gear doors:3x1,5-3kg mini servo

Nose steering:6kg mini servo