Carbonite-QS(4802DR-200-11)
-
Upload
lukaszanco -
Category
Documents
-
view
78 -
download
1
Transcript of Carbonite-QS(4802DR-200-11)
Switcher Specifications
Information in this document is subject to change without notice.© 2013 Ross Video Limited. All rights reserved.Contents of this publication may not be reproduced in any form without the written permission of Ross Video Limited. 4802DR-200-11
Video Production Technology
Frame Ports and Pinouts
INPUTS
1 2 3 4 5
1
1
PSL
SERIALGPIO
TALLYPS 2PS 1
Y Pb Pr
HDMI
LTC2
OUTPUTS 2 3 4 5 6 7 8 PV PGM OUT1 OUT2 IN REF
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Y Pb Pr
HDMI
Y Pb Pr
HDMI
Y Pb Pr
HDMI
GPI I/O Serial
Panel
Network
Tally
Power
Video Inputs/Outputs/Reference
Pin12345678
RS-422Tx+Tx-Rx+n/cn/cRx-
GroundGround
Serial(female RJ-45)
GPI I/O(female DB37)
Pin12345678910111213141516171819
SignalGPI I/O 1GPI I/O 2GPI I/O 3GPI I/O 4GPI I/O 5GPI I/O 6GPI I/O 7GPI I/O 8GPI I/O 9GPI I/O 10GPI I/O 11GPI I/O 12GPI I/O 13GPI I/O 14GPI I/O 15GPI I/O 16GPI I/O 17GPI I/O 18GPI I/O 19
Pin202122232425262728293031323334353637
SignalGPI I/O 20GPI I/O 21GPI I/O 22GPI I/O 23GPI I/O 24
GroundGPI I/O 25GPI I/O 26GPI I/O 27GPI I/O 28GPI I/O 29
GroundGPI I/O 30GPI I/O 31GPI I/O 32GPI I/O 33GPI I/O 34
--
Tally(female DB37)
Pin12345678910111213141516171819
TallyCommon (2-6, 20-25)
Tally 1Tally 2Tally 3Tally 4Tally 5Tally 6Tally 7Tally 8Tally 9Tally 10Tally 11Tally 12Tally 13Tally 14Tally 15Tally 16Tally 17
Common (13-18, 32-37)
Pin202122232425262728293031323334353637
TallyTally 18Tally 19Tally 20Tally 21Tally 22Tally 23Tally 24Tally 25Tally 26Tally 27Tally 28
Common (7-12, 26-30)Tally 29Tally 30Tally 31Tally 32Tally 33Tally 34
Specifications
Video Output SpecificationsReturn LossRise and Fall Time
Signal LevelDC OffsetOvershootHD Mode
> 17dB @ 1.5GHz800ps +/- 10% (SD)240ps +/- 10% (HD)800mV +/- 10%0 Volts< 10%10-bit SMPTE-292M serial digital
HDMI Input FormatsVGASVGA XGASXGA1080i1080p
640×480 (4:3)800×600 (4:3)1024×769 (4:3)1280×1024 (5:4)1920×1080 (16:9)1920×1080 (16:9)
SDI Input Formats480i 59.94Hz
576i 50Hz720p 59.94Hz
720p 50Hz1080i 59.94Hz
1080i 50Hz1080pSF 23.98Hz
1080pSF 251080pSF 29.97
Panel Power ConsumptionCarbonite 10Carbonite 1-ACarbonite 1MCarbonite 2 Carbonite 2MCarbonite 2SCarbonite 2X
24W 2.0A 12V30W 2.5A 12V30W 2.5A 12V42W 3.5A 12V50W 4.2A 12V54W 4.5A 12V66W 5.5A 12V
Frame Power ConsumptionCarboniteCarbonite+Carbonite MM
90W 7.5A 12V110W 9.2A 12V
125W 10.4A 12V
Default ValuesFrame IP (LAN1)Frame IP (LAN2)FTP User nameFTP Password
192.168.0.1230.0.0.0
userpassword Tally Rating
Input Voltage:Maximum Current:Impedance:
24VAC (rms) / 40VDC120mA
< 15 ohms
TemperatureOperating:Storage:
0 - 40°C (32 - 104°F)-20 - 85°C (-4 - 185°F)
Input VoltagesPanel/Frame 100 - 120V~
220 - 240V~47-63Hz
INPUTS
1 2 3 4 5
1
1
PSL
SERIALGPIO
TALLYPS 2PS 1
Y Pb Pr
HDMI
LTC2
OUTPUTS 2 3 4 5 6 7 8 PV PGM OUT1 OUT2 IN REF
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Y Pb Pr
HDMI
Y Pb Pr
HDMI
Y Pb Pr
HDMI
ReferenceIn
SDI Inputs
Carbonite MultiMedia FrameAnalog Inputs HDMI Inputs
Output BNCs ReferenceOut
Linear TimecodeInput
Power Switch. USB Port, and Diagnostics
POWER
FRM
UPG
D1 2 3 4 5 6 7 8 PA
NEL
MC
POW
ERPS
1PS
2
UPGRADE
12345678
ON
OFF
USB
StatusLEDs
DIPSwitches
Power Switch
Carbonite Frame (Interior front)
Note: MultiViewers can be assigned to any assignable output, or to PV.
Note: The Carbonite 10 control panel has a power switch to power it on, or off. The other Carbonite control panels power on automatically when the power supply is plugged in.
Note: GPI Output pin 37 is not used at this time.
FRAME NEXTPS 2PS 1
Carbonite 2MPower
Note: Only one of Analog Input 1, HDMI 1, and SDI Input BNC 6 can be used at the same time. The same applies to Input BNCs 12, 18, and 24.
Video Input SpecificationsEqualization(using Belden 1694 cable)ImpedanceVideo Inputs, SDI
Video Inputs, HDMI
Video Inputs, AnalogReference Inputs(non-terminating, looping)
>100m @ 1.5 Gb/s>300m @ 270 Mb/s (5°-40°C)75 ohm, terminatingSMPTE 259M/292M serial digital (non-looping)HDMI 1.4High Speed HDMI Cable (Max 10m)Levels — 1V peak-to-peak, nominalStandard Definition — analog blackHigh Definition — tri-level sync
INPUTS
1 2 3 4 5
1
1
PSL
SERIALGPIO
TALLYPS 2PS 1
LTC2
OUTPUTS
2 3 4 5 6 7 8 PV PGM OUT1 OUT2 IN REF
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
ReferenceIn
Carbonite+/Carbonite Frame
Output BNCs ReferenceOut
SDI Inputs
Linear TimecodeInput
Note: If you purchased the 16 input variant of Carbonite (116 or 216), only the first 16 Input BNCs on the back of the frame can be used.
Printed In Canada
Frame Installation and Cabling
Video Production Technology
POWER
FR
M U
PG
D1 2 3 4 5 6 7 8 P
AN
EL
MC
PO
WE
RP
S1
PS
2
UPGRADE
12345678
ON
OFF
2
INPUTS1
23
45
1
1
PSL
SERIAL
GPIO
TALLY
PS 2
PS 1
YPb
Pr HDMI
LTC
2
OUTPUTS
23
45
67
8PV
PGM OUT1 OUT2IN
REF
67
89
1011
1213
1415
1617
1819
2021
2223
24
YPb
Pr HDMI
YPb
Pr HDMI
YPb
Pr HDMI
Threaded Rubber Bumpers
4
INPUTS1
23
45
1
1
PSL
SERIAL
GPIO
TALLY
PS 2
PS 1
YPb
Pr HDMI
LTC
2
OUTPUTS
23
45
67
8PV
PGM OUT1 OUT2IN
REF
67
89
1011
1213
1415
1617
1819
2021
2223
24
YPb
Pr HDMI
YPb
Pr HDMI
YPb
Pr HDMI
5/16 HexNuts
3
Rack Mounting Power and Control Cabling
Powering On Switcher
Frame Door Opening
Frame Dust Filter
INPUTS1
23
45
1
1
PSL
SERIAL
GPIO
TALLY
PS 2
PS 1
YPb
Pr HDMI
LTC
2
OUTPUTS
23
45
67
8PV
PGM OUT1 OUT2IN
REF
67
89
1011
1213
1415
1617
1819
2021
2223
24
YPb
Pr HDMI
YPb
Pr HDMI
YPb
Pr HDMI
Rail Guide
RetainingBolts
Rack MountArm
2
Shielded Twisted Pair Maximum 200m cable
length
Connect video input sources as needed
Note: The Carbonite 10 control panel has a power switch that must be used to power on the control panel. All other Carbonite control panels power on when plugged in.
Note: It is recommended that you always connect the AC Power Adapter to the Control Panel before connect-ing to Mains Power.
Note: The Dust Filter located inside the frame door should be kept clean and free of dust buildup to ensure proper cooling of the frame. Always ensure that the Dust Filter is covering all the holes in the door.
Remove frame door before cleaning the dust filter.
INPUTS
1 2 3 4 5
1
1
PSL
SERIALGPIO
TALLYPS 2PS 1
Y Pb Pr
HDMI
LTC2
OUTPUTS 2 3 4 5 6 7 8 PV PGM OUT1 OUT2 IN REF
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Y Pb Pr
HDMI
Y Pb Pr
HDMI
Y Pb Pr
HDMI
POWER
FRM
UPG
D1 2 3 4 5 6 7 8 PA
NEL
MC
POW
ERPS
1PS
2
UPGRADE
12345678
ON
OFF
Power Switch
FRAME NEXTPS 2PS 1
Carbonite 2M
1
INPUTS1
23
45
1
1
PSL
SERIAL
GPIO
TALLY
PS 2
PS 1
YPb
Pr HDMI
LTC
2
OUTPUTS
23
45
67
8PV
PGM OUT1 OUT2IN
REF
67
89
1011
1213
1415
1617
1819
2021
2223
24
YPb
Pr HDMI
YPb
Pr HDMI
YPb
Pr HDMI
Rack MountArm
Unlocked
Locked
Having a problem? Call our free, 24-hour technical support hotline to speak with a live product specialist located right here in our facility. Tel: (+1) 613 • 652 • 4886 Email: [email protected]
Connect external reference or use internal reference
Frame DustFilter
Connect Programand Preview Out
Connect aux outputs as needed
FRAME
POWER
EXTLINKPS 2PS 1
12 V4A
ON
OFF
Carbonite 10
Power Switch
1
SDIAnalog
(YPbPr Cable)HDMI
(High Speed HDMI Cable)