CALIBRACION PPC-101

download CALIBRACION PPC-101

of 2

Transcript of CALIBRACION PPC-101

  • 8/13/2019 CALIBRACION PPC-101

    1/2

    J,M- PPG.IOI Technical Manualll Set-up Proceduresll.B System Parameter Mode

    @h6. Press Kglto sav a change and to progess to thenext kerrtord.T. Press ffi *",, @," retum to test mode, or press@ rn"n ffi," return to normat operating mode.

    ll.C Calibration Mode1- Enter Test Mode {see section ll.A for details.}f=I - AcctoAR Sunpee rfErlroz. p ress l,ffi u n u W,*,ni8 Hnii3fr '"+"', L:' i n "cale will indicate three.point or two-point span ad-justment mode and the fraction (i.e. - 0/2, 112 ar 2l2forthree-point) of full-scale, in kilograms, that should beplaced on the platform.f------l r{El6il{t r---l

    AoLh

    3. lf the scale is in twe.point span adjustment mode, pressm * enter three-point mode.

    4. Clear the platform, wait for stable indication and press[+l Q,car [c r,,{J l. (* $yoc; " l.{oL-'?t - (.o.tJc- o Lo GltL*.iJ* Lr.lo Qr..v,vtIn - es?r.* 1,c s^tqo, e[ rrrltnL, Jr ci.L r,.el 9rr?loJ. O5. Place one-half of the full scale weight (in kilograms) onthe olatform,i-ffd* L GpcrLJ l"{"1 /Q,ct-^,, f,o"Example: lf the scale capacis is 5 kg/10 lb, place 2500g on the platform.

    6. Wait for stable indication and press @3 YCO-1082-07-01

  • 8/13/2019 CALIBRACION PPC-101

    2/2

    ol Technical ManualIl Set-up Proceduresll.C Calibration Mode7 . Add sufficient weight to the platform to bring the total tothe full-scale weight in kilograms.

    Example: lf the scale capacity is 5 kgl10lb, place an-other 2500 g on the platform for a total of 5 kg.ISt\--J to save the new Wait for stabilization acalibration points and retum to Test Mode. The displayshould indicate 20000 counts +/- 2 counts.

    A ?* u [[t;, Qretionnr o rrL press KIat any time in the span-adjustment to exit toTest Mode without saving any new calibration points.10. press E,n"n Wl" retum to normal operatingTo9"' frnoo' .l Q.cinca tuvs 0to,rcioh .oll.D Factory Parameter Mode1. Enter Test Mode (see section ll.A for details.)2. Enter Calibration Mode (see section ll.C for details.)3. Press @ ""0 ffi," enter Factory parameter Mode..The steps are the same as in System parameter Mode(see Section ll-B) with the exception that the keywordsprogress from 51 through gg.

    Nole: Use the Factory Parameter List in Section lV.Cto locate the function to be changed- Use the StandardFactory Parameter Settings List in Section lV.D to de_termine the appropriate parameter value to enter.

    rl--*--rTfH$tT r---- -l

    4 YCO-1082-07-01