Cabover Camper Framing 1
-
Upload
leonel-rodriguez -
Category
Documents
-
view
9 -
download
0
description
Transcript of Cabover Camper Framing 1
Cabover camper framing 1
The finished floor unit typical to campers in the 9' to 11' sizes. The 5/8" plywood is
glued and fastened to 2" x 2" framework.
The box side uprights are a "sandwich" structure of 3/8" plywood, 1" framing, and
interior plywood paneling (not yet installed). Note the insulation.
Preliminary mock-up. After the interior panels are installed, the box sides will be glued
and fastened in place.
Cabover camper framing 2
The 3/8" plywood side wings rest on top of the box side uprights and extensions. Note
2" x 2" cleats on outer edge for fastening side walls.
The side wall is built on a base of plywood, directly over the patterns provided.
The second side is assembled over the top of the first side.
Cabover camper framing 3
The front wall is covered with interior plywood paneling prior to trimming around the
edges and opening with a router or sabre saw.
The side walls are fastened into the longitudinal 2" x 2" cleats on the outer extremity of
the side wings. Note the clamps holding the walls in position.