Cable Railing Assembly instructions - Keuka Studios · Cable Railing Assembly instructions Step 2...
Transcript of Cable Railing Assembly instructions - Keuka Studios · Cable Railing Assembly instructions Step 2...
Corner Intermediate End Double End Stair Top Stair Intermediate Stair End
Parts provided by Keuka Studios, inc. (Some parts may not apply to your railing).
Other parts required (Sourced Separately)
Cable & Fittings Nuts and Bolts Wood for Top Rail
Available from:
The Cable Connection
52 Heppner DriveCarson City, NV 897061-800-851-2961Fits Invisaware 1/8””or 3/16” cable fittings.
:- (4) 3/8”-16 X 1-5/8 Stainlesssteel carriage head bolts or 8
- (6) ½”- x (length varies per your band joistthickness) Stainless Steel Hex head threaded boltsor lag bolts if access to back side is not possible.
Per End Post
Per Intermediate Post
Per Corner Post
:- (2) 3/8”-16 X 1-5/8 Stainlesssteel carriage head bolts or 4 #14 Flat head screws(if posts were ordered for them).- (4) 3/8” x ? ”L Stainless steelLag bolts.
:- (8) 3/8”-16 X 1-5/8 Stainlesssteel carriage head bolts.- (6) ½”- 16 x (length varies per your band joistthickness) Stainless Steel Hex head threaded bolts.
Cap Rail Mounting:
Joist Mounting:
Cap Rail Mounting#14 Flat head screws
(if posts were ordered for them).
Available locallyor from:Bristol Valley Hardwoodwww.bristolvalley.com
- 5/4” x 6 IPE (Brazilian Walnut)decking.
Or-2 x 6 wood of your choice. Shouldbe knot free.Note: Composite lumber notsuitable for top rail.
Tools Required
- Electric Drill- Drill bits- Small level- Masons String- Socket Set-”C” Clamps or wood clamps- Vise Grips
Other- Anchor Seal (if using IPE wood).- Finish for top rail.
Cable Railing Assembly instructions
Page 1
Cable Railing Assembly instructions
Step 1 Bolt On all Corner and End Posts
Thru Bolt if possible.
Level top and sideof posts, shim if necessary
Double Band JoistOverhung Decking
Double Band JoistTrimmed DeckingSet post down fromtop edge 1 -1/2”
Solid Thick JoistsOverhung Decking
Page 2.
Typical Mounting Conditions
Cable Railing Assembly instructions
Step 2 Bolt On Intermediate Posts
Use a masons string line toensure the tops of the posts are all in line.
Use 3/8” Lag Bolts,Shim if necessary.
*
* 42” Spacing MAX. (60” if using cable spacers). Page 3.
Cable Railing Assembly instructions
Step 3 Add Top Rail.
Miter & pre drilltop rails
Counter sink (slightly)if using a hard wood(like IPE).
Attach top rail with stainless steelcarriage bolts, washers and nuts.
Page 4.
Cable Railing Assembly instructions
Step 4 Install Cable
http://keuka-studios.com/cable_rail_installation.html
For Installation of cables, download the cable instructions from:
Page 5.
Also see photos on our web site