CA2 - 24.11.20 - BEST FRIENDS - FOREST

3
Click To Watch The Online Tutorial Take a piece of white card stock and two ink pads. Press the ink pads onto the stencil and spray with water. Press the card stock onto the stencil and then lift off to reveal the design. Step One: STAMP - BEST FRIENDS STENCIL - FOREST Craft Academy Forest Stamp Eureka or Stamping Platform Foam Tape Acetate Sequins Distress Inks White Card Stock Craft Academy Best Friends Stencil Creative Card 6 Dies Die cutting machine Top Folding Note Card Coloured Card Stock Glue

Transcript of CA2 - 24.11.20 - BEST FRIENDS - FOREST

Click To Watch The Online Tutorial

Take a piece of white card stock and two ink pads. Press the ink pads onto the stencil and spray with water. Press the card stockonto the stencil and then lift off to reveal the design.

Step One:

STAMP - BEST FRIENDSSTENCIL - FOREST

Craft Academy Forest Stamp

Eureka or Stamping Platform

Foam Tape

AcetateSequins

Distress Inks

White Card Stock

Craft Academy Best Friends Stencil

Creative Card 6 DiesDie cutting machine

Top Folding Note CardColoured Card Stock

Glue

Step Two:

Step Three:

Step Four:

Step Five:

Use the creative card nesting dies and take two dies that are approximately an inch in size apart. Place the dies over the stencilled card stock and run through the die cutting machine. This will create an aperture.

Stamp out one of the girl stamps onto a piece of white card stock. Use your gossip alcohol markersto colour her all in. Then cut her out.

Use the creative card 6 dies and cut another of the larger size that you used previously. However time do not use the smaller die in the centre. Do this on white card stock.

Stamp out the girl again but this time onto a piece of acetate. Use glue and apply it to the centre of the die cut from step two. Then stick the girl behind the die cut aperture to frame her.

Step Two:

Step Three:

Step Four:

Step Five:

Take your foam tape and stick around the acetate image to create a border for your sequins.

Stick the centre of the aperture (waste) from step two onto the white die cut from step four. Add some sequins to the centre of this and then stick the frame with the acetate and foam pads over the top to create a shaker card.

Take two pieces of coloured card stock and stick them to the white top folding note card on a slight angle.

Use foam pads or tape to stick the shaker element to your card. Then stick the coloured girl from step three to the front of the card. Then add a banner and sentiment of your choice.