BUILDING STRUCTURE (ARC 2522/2523)

PROJECT 2: EXTENSION OF A R.C. BUILDING

TUTOR: MR. ADIB

GROUP MEMBERS:

Adeline Ting Yuh Chee 0314648

Cheng Chen Liang 0310043

Lee Run Sen 0308226

Lim Fou Sing 0314997

Ng Teng Wern 0315014

Tan Kwok Seong 0314700

Teo Kean Hui 0310165

Tsai Wan Ching 0315185

TABLE OF CONTENT

1.0 Introduction

2.0 Measured drawings

3.0 Structural drawings

4.0 Conclusion

5.0 Individual proposal

- Adeline Ting Yuh Chee

- Cheng Chen Liang

- Lee Run Sen

- Lim Fou Sing

- Ng Teng Wern

- Tan Kwok Seong

- Teo Kean Hui

- Tsai Wan Ching

1.0 Introduction

In a group of 8, we are required to obtain floor plan of a bungalow and carry out ananalysis on the structural framing and produce a set of structural drawings whichincludes foundation plan, ground floor plan, first floor plan, second floor plan and roofplan. Individually, each member has to propose an extension work of the bungalowthat does not exceed 100sq.m for each floor. This extended area should be framedusing structural members such as columns, beams, slabs and trusses. Next, we arerequired to identify and analyze a minimum of 6 beams, 4 columns and the load actingon it.

The case study that we have chosen is a 3 storey bungalow, which is located inHartamas Height, Kuala Lumpur. This bungalow is developed since early 2009 andcompleted in late 2010. The built up area of a single unit is approximately 573.2 sq.m,which includes a total of 332.91 sq.m built area and 240.29 sq.m covered exteriorarea. This bungalow consists of sub-basement, ground floor and first floor. The interiorof this bungalow is made up of an entertainment room, living room, dining, kitchen,bedrooms, guest room and study room; while the exterior consists of a swimming pool,car porch and a yard.

2.0 Measure Drawings

No floor plan was obtained due to time constraint. So a quick measured drawing ofthe of the house was made, in order to obtain the size of floor plan and proceed tostructural plans by our own analysis.

3.0 Structural Drawing

A set of structural plan drawings are produced by the group, locations of columns andbeams are found through observation and analysis. Grid lines are then produced afterfurther developing and discussion with the tutor.