Building and Property Infrared Inspection Auckland

6
What Inspection Services Do DRYSCAN Offer? At Dryscan, we offer a range of different services of Building Inspection Auckland  to ensure your home is dry and safe. Our pre-purchase Report or pre-sale house inspections will ensure you end up in a family home that is healthy and happy rather than leaky, unsound and in need of expensive repairs. Infrared Moisture Inspection In many cases, moisture can be hidden within walls, slowly doing damage with no visible evidence to the naked eye. At Dryscan we use sophisticated infrared technology including NZ Standard moisture meters to detect moisture. Infrared technology uses the part of the light spectrum the human eye cannot see. These cameras are sensitive to the slightest variations in temperature and therefore have the ability to detect moisture hidden within walls. Building Inspection The words ‘leaky buildings’ and ‘moisture’ strike fear into many people. The response is often “No, I don’t have a problem. Its just the cold side of the house”. But after 10000 inspections, we stopped counting. We had only seen 20 houses without any moisture issues. Not all that failed had serious issues but they still needed addressing before significant damage occurs. The moisture detectives at Dryscan can help diagnose where and what is affected and how bad it is. We use state of the art infrared technology to see into your walls and ceilings to show thermal anomalies and then track the moisture to its source. Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

description

Dryscan provide Infrared and Drying solution for Building and Property Inspection and also work for pre purchase report for building in Auckland. Drybuild Infrared Solutions was formed to provide in-depth, non-invasive moisture testing and reporting for buildings. It is used to investigate moisture issues and reporting procedure for Building inspection.

Transcript of Building and Property Infrared Inspection Auckland

Page 1: Building and Property Infrared Inspection Auckland

What Inspection Services Do DRYSCAN Offer?

At Dryscan, we offer a range of different services of Building Inspection Auckland to ensure yourhome is dry and safe. Our pre­purchase Report or pre­sale house inspections will ensure you endup in a family home that is healthy and happy rather than leaky, unsound and in need of expensiverepairs.

• Infrared Moisture Inspection

In many cases, moisture can be hidden within walls, slowly doing damage with no visible evidenceto the naked eye. At Dryscan we use sophisticated  infrared technology including NZ Standardmoisture meters to detect moisture. Infrared technology uses the part of the light spectrum thehuman eye cannot see. These cameras are sensitive to the slightest variations in temperature andtherefore have the ability to detect moisture hidden within walls.

• Building Inspection

The words ‘leaky buildings’ and ‘moisture’ strike fear into many people. The response is often “No,I don’t have a problem. Its just the cold side of the house”.

But  after  10000  inspections,  we stopped counting.  We had only   seen 20 houses  without  anymoisture  issues.  Not  all   that   failed  had serious   issues but   they still  needed addressing beforesignificant damage occurs. The moisture detectives at Dryscan can help diagnose where and whatis affected and how bad it is. We use state of the art infrared technology to see into your walls andceilings to show thermal anomalies and then track the moisture to its source.

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

Page 2: Building and Property Infrared Inspection Auckland

Bryce Hall of Dryscan knows only too well. He’s lived through a leaky home which put stress on hishealth, marriage, family and the joinery business. “When I saw this infrared technology, I knewthat this would help a lot of people with leaks and moisture issues, or to help them avoid buying aleaky home.”

• Track and Trace Inspection

Do you have a single or annoying leak that you can’t find the source of? You’ve had your builder,roofer and plumber look with no luck?

Call Dryscan and get a track and Trace Inspection and report. We will find the source of your leakor you do not have to pay.

• Methamphetamine (P­Lab) Screening

If you have one reason to suspect a house might have been used as a P lab, don;t take any chances.The chemical residue left behind can be seriously dire to you and your family’s health. At Dryscan,we offer screenings to detect drug contamination.

LEAK DETECTION:

Water leaks can occur as a result of many factors such as:

Floods from laundries, kitchens and bathrooms etc 

Rain leaks 

Roof leaks 

Cladding leaks 

Joinery Leaks 

Deck leaks 

Plumbing leaks 

Flooding rom outside 

Internal leaks

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

Page 3: Building and Property Infrared Inspection Auckland

WE’VE GOT YOU COVERED FOR:

Moisture Ingress and Leak Detection 

Watertightness Reports 

Leaky Building Diagnostics 

Pre­Purchase Inspections 

Track and Trace Reports 

Heat Loss Inspection 

Pre­Sale Inspections 

Roof Inspections

It is essential that leaks are not only stopped as soon as possible, but also that the affected areasare dried out  once the cause of   the  leak has been found and repaired.  Our dynamic team atDryscan can safely and effectively dry out any affected areas.

HOW DOES THE DRYSCAN PROCESS WORK?

A member of the Dryscan team will come to your house for a pre­puchase or pre­sale inspectionand beign with an internal inspection of each room. We’ll check every wall and ceiling (wherepossible)   including top and bottom plates  using thermal  imaging and a non­invasive moisturemeter.

We will then do an external check focusing on areas where common problems occur such as roofs,decks,   ballustrades,   cladding,   flashing   and   ground   clearnace.Following on from that we’ll hen provide a verbal report followed by a written report so that youcan buy with confidence or sell with a good conscience. Best of all the results are instant so you;llfind out right away!

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

Page 4: Building and Property Infrared Inspection Auckland

WHY SHOULD YOU CHOOSE DRYSCAN?

Customer Service:

Dryscan delivers a professional yet friendly service where we’ve achieved some great results andfeedback over the years

Experience:

We’re fully qualified with over 30 years industry experience

Professional Indemnity Insurance:

For diagnosing leaky buildings for your peace of mind.

Assurance:

We stick to thorough processes and procedures and offer a 6 point guarantee so that you’ll knowyou’re getting a service you can count on.

The Best Equipment:

At Dryscan we’ve sourced superior, high resolution, high performance cameras. This means a 45%higher performance than most traditional infrared detectors used.

Track & Trace Report:

If we don’t find the source of the leak, you don’t have to pay

DANGERS OF NOT BOOKING A PROPERTY INSPECTION FROM DRYSCAN:

You could find yourself living in a leaky home 

You could lose tens or hundreds of thousands of dollars of your investment 

Your house could be structurally unsound 

You and your family’s health could be compromised

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

Page 5: Building and Property Infrared Inspection Auckland

The foundation of DryScan began over ten years agowith a Drying Solutions company which specialisedin the drying of timer framework in buildings priorto the pre­line building inspection.

This led to an awareness of the continued problem ofmoisture   in  both  new and  existing  homes,  and   thenwith the explosion of   the “leaky building syndrome”,the   company   founders   identified   the   need   for   moredetailed  testing of   the  moisture damage occurring  inspecific areas.

Drybuild Infrared Solutions was formed to provide in­depth, non­invasive moisture testing and reporting forbuildings.   Having   thoroughly   researched   equipment

and procedures and travelling internationally to test equipment and investigate moisture issues, ahigh­tech   infrared   thermal   imaging   process   with   comprehensive   reporting   procedures   wasestablished in New Zealand. Drybuild pioneered this leading edge technology in New Zealand andbecame the first building inspection company to adopt purpose built infrared thermal imaging foruse  in building inspections.  (Some have since tried to emulate what Drybuild started, but  theexperience and cutting edge technology…)

Bryce Hall  joined Drybuild in May 2008 working in Auckland and surrounding areas. In 2012Bryce changed the company name toDryScan and has continued to build upon the experience andknowledge   that  was  Drybuild’s   foundation;   synonymous  with   integrity,   reliability,   quality   andservice. DryScan still uses the most accurate hand­held infrared camera in New Zealand enabling itto see up to 45% more than most other infrared cameras being used currently.

To put it simply, DryScan does it best! Having developed the systems, software and technology,DryScan is ahead of the rest. We are passionate about what we do and you can rest assured andhave  peace  of  mind   that  you  will  have   the  expertise,   knowledge  and  professionalism  that   isrequired when dealing with your largest asset.

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.

Page 6: Building and Property Infrared Inspection Auckland

For More Detail:

www.dryscan.co.nz

Copyright © 2014 Dryscan Ltd ®. All Rights Reserved.