Blood Collection with the S-Monovette - Sarstedt · 2015-09-03 · The ideal solution for perfect...
1
The ideal solution for perfect results Preparation Blood Collection with the S-Monovette ® Sample Handling & Disposal Citrate 644d-201 This document may contain information on products that may not be available in particular countries Technical modifications reserved Citrate ESR Heparin EDTA Fluoride Citrate Fluoride CPDA 1 CTAD Mix samples thoroughly 8 - 10 x by gently inverting the S-Monovette ® Ensure CORRECT filling for correct results EDTA ESR Citrate Fluoride Aspiration method – The gentle method for increased patient comfort Vacuum method 3 – Always a fresh vacuum Blood Collection After blood collection, store the S-Monovette ® Serum / Serum gel in a vertical position for 30 min. Ensure correct storage 1 2 Prior to venipuncture: “Warn” the patient click ✓ 1 2 1 2 Prior to venipuncture: “Warn” the patient click ✓ or click 4 click Please be aware that the topics addressed here („Blood Collection with the S-Monovette ® “) are recommendations only and do not, under any circumstances, replace medical, scientific or technological expertise. www.sarstedt.com • [email protected] SARSTEDT Ltd. · 68 Boston Road · Leicester LE4 1AW · Tel.: 0116 235 9023 · Fax: 0116 236 6099 · [email protected] · www.sarstedt.com Attach the tourniquet a few inches above the puncture site Disinfection Barcode line Attach the barcode label Disinfect in accordance with internal guidelines Observe order of draw (EU colour code) OR Blood culture Serum / Serum Gel blood 1a Citrate blood 1b,2 Fluoride / Citrate-Fluoride blood Heparin / Heparin Gel blood EDTA blood Constriction <1min 1a Gurr et al “Musterstandardarbeitsanweisung Präanalytik” J Lab Med 2011 1b Recommendation in accordance with CLSI standard H3-A6(GP 41-A6): „Procedures for the Collection of Diagnostic Blood Specimens by Venipuncture; Approved Standard – Sixth Edition“. 2 It is recommended to draw a discard tube first when a citrate tube is the first tube needed. 3 To begin blood collection gently, we generally recommend using the first S-Monovette ® with the aspiration method. Then continue with the vacuum method. 4 You can also activate the needle protector using your index finger. For safe operation, make sure to press against the lower end of the protection device.
Transcript of Blood Collection with the S-Monovette - Sarstedt · 2015-09-03 · The ideal solution for perfect...
The ideal solution for perfect resultsPreparation
Blood Collection with the S-Monovette®
1
Sample Handling & Disposal3
Citrate
644d-201 This document may contain information on products that may not be available in particular countries Technical modifications reserved
CitrateESRHeparinEDTAFluorideCitrate FluorideCPDA1
CTAD
Mix samples thoroughly 8 - 10 x by gentlyinverting the S-Monovette®
Ensure CORRECT fillingfor correct results
EDTA
ESR
Citrate Fluoride
Aspiration method – The gentle method for increased patient comfort
Vacuum method3 – Always a fresh vacuum
Blood Collection2
After blood collection,store the S-Monovette®
Serum/Serum gel in a vertical position for30 min.
Ensure correctstorage
12
Prior to venipuncture:
“Warn” the patient
click✓
1
2
12
Prior to venipuncture:
“Warn” the patient
click✓
or
click4
click
Please be aware that the topics addressed here („Blood Collection with the S-Monovette®“) are recommendations only and do not, under anycircumstances, replace medical, scientific or technological expertise.
www.sarstedt.com • [email protected]
SARSTEDT Ltd. · 68 Boston Road · Leicester LE4 1AW · Tel.: 0116 235 9023 · Fax: 0116 236 6099 · [email protected] · www.sarstedt.com
Attach the tourniquet a few inches above the puncture site
DisinfectionBarcodeline
Attach the barcode label
Disinfect in accordance with internal guidelines
Observe order of draw(EU colour code)
OR
Blood culture
Serum / Serum Gel blood1a Citrate blood1b,2
Fluoride / Citrate-Fluoride blood
Heparin / Heparin Gel blood
EDTA blood
Constriction
<1min
1a Gurr et al “Musterstandardarbeitsanweisung Präanalytik” J Lab Med 2011 1b Recommendation in accordance with CLSI standard H3-A6(GP 41-A6): „Procedures for the Collection of Diagnostic Blood Specimens by Venipuncture; Approved Standard – Sixth Edition“.2 It is recommended to draw a discard tube first when a citrate tube is the first tube needed.3 To begin blood collection gently, we generally recommend using the first S-Monovette® with the aspiration method. Then continue with the vacuum method.4 You can also activate the needle protector using your index finger. For safe operation, make sure to press against the lower end of the protection device.
