Bliss electronic [[[�)PIGXVSRMGW����GSQ

Select language

Check the size of

memory on BUSB

series.

For 150s version, it

would show PM6608.

For 300s version, it

would show PM6616.

Showing the minimum

requirement of

memory for the sound

entered.

If it is showing

PM6632 or larger

number then the

module, please reduce

the sample rate. Group:

Group of sounds

that would plays

back for each

activation.

It is played in

sequential

Wav / mute:

Sound files wish

to play. If

multiple sound is

entered it. It

would be play in

sequential.

Rate:

Sample rate.

Higher sample

rate gives higher

sound quality

O1:

LED output

setting

Flash:

LED flashing

speed setting P]�

XLEX�]SY�[ERX�XS�TPE]�1YPXMTPI�ÅPIW�TPE]MR�WIUYIRGI�]SY�IRXIV�LIVI�

VIUYMVIH�QIQSV]�JSVXLI�WSYRH�IRXIVIH�

Each Key

represent each

switch/sensor

configuration.

Each key can play

back different

sounds

W�IEGL

Trigger function

Select wish

function accord

to application

[LMGLHMRK

PWM for modules

speaker-only

DAC for modules

with audio-out.

Please try and

select the volume

that apply best.

GoldWave is a

simple shareware

recommended for

preparing sound

files.

Save you sound file

as Wave (*.wav)

Attribute: PCM,

signed, 16bit,

mono

XLI

Select K1,

◦ Select type of trigger function

◦ Select DAC for voice output

◦ Enter the wav file and select sample rate,

◦ Select LED output if needed.

Repeat for K2~k4

Press “>>PM66” to start

recording

Select K1,

◦ Select type of trigger function

◦ Select DAC for voice output

◦ Enter the wav file and select sample rate

◦ Set LED output if needed

Select 2 under group

◦ Enter the wav file and select sample rate.

◦ Set LED output if needed

Repeat this for group 3 and up if

needed.

Press “>>PM66” to start recording

Please contact Bliss if there is

any further question

4PIEWI�GSRXEGX�)PIGXVSRMGW����GSQMJ�]SY�LEZI�ER]�UYIWXMSRW�