Bevel Square.pdf

7
Project: Bevel Square Page 1 of 7 Bevel Square A bevel square, which is an essential tool for marking out dovetails and other joints with angles, greater or smaller than 90 degrees, can be made on the same lines as the try square. Again the dimension given are only for guidance. Project from WWW.CRAFTSMANSPACE.COM

Transcript of Bevel Square.pdf

Page 1: Bevel Square.pdf

Project: Bevel Square Page 1 of 7

Bevel Square A bevel square, which is an essential tool for marking out dovetails and other joints with angles, greater or smaller than 90 degrees, can be made on the same lines as the try square. Again the dimension given are only for guidance.

Project from WWW.CRAFTSMANSPACE.COM

Page 2: Bevel Square.pdf

Project: Bevel Square Page 2 of 7 Parts List

Project from WWW.CRAFTSMANSPACE.COM

Page 3: Bevel Square.pdf

Project: Bevel Square Page 3 of 7 Assembly Drawing

Project from WWW.CRAFTSMANSPACE.COM

Page 4: Bevel Square.pdf

Project: Bevel Square Page 4 of 7 1. Stock

Project from WWW.CRAFTSMANSPACE.COM

Page 5: Bevel Square.pdf

Project: Bevel Square Page 5 of 7 2. Staright Edge

Project from WWW.CRAFTSMANSPACE.COM

Page 6: Bevel Square.pdf

Project: Bevel Square Page 6 of 7 Standard Parts

Assemblage instructions

1. Fit the straight edge into the socket so there are no overlaps. Mark a central point 20mm from the end of the stock and drill a D6mm hole right through both pieces of wood.

Project from WWW.CRAFTSMANSPACE.COM

Page 7: Bevel Square.pdf

Project: Bevel Square Page 7 of 7

2. Pass the screw through this hole and the two washers and tighten the wing nut.

Project from WWW.CRAFTSMANSPACE.COM