Berolin Ariston tampereen leimasintehdas
1
Berolin-Ariston P Berolin Ariston P is a stamping ink which is resistant to washing and the usual solvents used in dry cleaning, which does not aack the fabric. Important note: Always wash fabric to remove texle finish prior to stamping. Properes: This stamping ink is very economical providing intense, colour fast markings which are washable aſter 4 to 5 hours. Applicaon: We recommend Berolin Ariston P for marking all natural fibers such as coon, silk, linen as well as rayon and fleece. Synthec fibers such as nylon, Perlon, Elastane or Polyacrylic are not parcularly suitable for marking with Berolin Ariston P, because as a rule, the fibers have a closed surface prevenng penetraon into the fiber. However, use may be possible from case to case. pH value: ~6 ±1 (20°C) Viscosity: low to medium viscosity, ~20 to 60 sec (Ford 4mm cup) Stamp material: Rubber or metal. Stamp pad material: We recommend unsaturated felt plate pads, however, normal felt pads are also suitable. The ink remains moist for stamping for about 3h before the ink dries out Thinner/cleaner: Thinner 465 Available standard sizes: 50ml/g · 250ml/g · 1000ml/g Opaque 01 02 03 04 05 21
Transcript of Berolin Ariston tampereen leimasintehdas
Berolin-Ariston P
Berolin Ariston P is a stamping ink which is resistantto washing and the usual solvents used in drycleaning, which does not attack the fabric.
Important note:Always wash fabric to remove textile finish prior to stamping.
Properties:This stamping ink is very economical providing intense, colour fastmarkings which are washable after 4 to 5 hours.
Application:We recommend Berolin Ariston P for marking all natural fibers such ascotton, silk, linen as well as rayon and fleece.Synthetic fibers such as nylon, Perlon, Elastane or Polyacrylic are notparticularly suitable for marking with Berolin Ariston P, because as arule, the fibers have a closed surface preventing penetration into thefiber. However, use may be possible from case to case.
pH value:~6 ±1 (20°C)
Viscosity:low to medium viscosity, ~20 to 60 sec (Ford4mm cup)
Stamp material:Rubber or metal.
Stamp pad material:We recommend unsaturated felt plate pads,however, normal felt pads are also suitable. Theink remains moist for stamping for about 3hbefore the ink dries out
Thinner/cleaner:Thinner 465
Available standard sizes:50ml/g · 250ml/g · 1000ml/g
Opaque
01 02 03 04 05 21
