belem_i_e_a4(portugal)

Belem Tower, Portugal : Assembly Instructions © Canon Inc. © A&A

http://www.canon.com/c-park/en/

Assembly Instructions

Mountain fold(dotted line)Make a mountain fold.

Valley fold(dashed and dotted line)Make a valley fold.

Scissors line(solid line)Cut along the line.

Cut in line(solid line)Cut along the line.

Glue spot(Red dot)Glue parts with the same number together.

Glue spot(Green dot)Glue within the same part.

Glue spot(Blue dot)Glue to the rear of the other part.

GlueThe glue spot(colored dot)shows where to apply the glue.

Tools and materials

Assembly tip

Caution

Scissors, set square, glue(We recommend stick glue), pencil, usedballpoint pen, toothpicks, tweezers, (useful for handling small parts)

Before gluing, crease the paper along mountain fold and valley fold lines and make sure rounded sections are nice and stiff.

Glue, scissors and other tools may be dangerous to young children so be sure to keep them out of the reach of young children.

View of completed model

Assembly Instructions : Seven A4 sheets (No. 1 to No. 7)

*Hint: Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.

* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.

* This model was designed for Papercraft and may differ from the original in some respects.

Before starting assembly : Writing the number of each section on its back side before cutting out the sections is highly recommended.(* This way, you can be sure which section is which even after cutting out the sections.)

Indicates where sections should be glued together.

[1] Assemble the base.

CAUTION

Do not hit other people with the pointed edges.Doing so could result in injury. Adults should make sure that children observe this caution.

© A&A

http://www.canon.com/c-park/en/


While gluing this part in place, adjust it to make sure the sides of

the base do not bulge out.


[2] Assemble the vents.


[3] Assemble the upper part of the building.

[2] Vent

Assemble the other parts in the same way.

Insert this part and glue it in place on the rear side.

Insert this part and glue it in place on the rear side.

Assemble the other parts in the same way.

Insert parts and from beneath part and glue them in place on the underside of part .

Assemble in the same way as part .


[4] Assemble the lower part of the building and glue the tower windows in place.

[3] Upper part of the building

Reinforce the cutout parts by gluing their rear sides to each other.

The other side of the tower


[5] Assemble the top level of the tower.

Attach these parts by matching this glue point to part .

[4] The building

Insert parts , , and from beneath part and glue them in place on the underside of part .


[6] Glue the observation towers to the building and glue the building to the base.

[1] Base

[5] Building

Glue these pieces in place by inserting them into the uneven parts of the walls.

Glue these pieces in place by inserting them into the uneven parts of the walls.

Finished!

Belem TowerLisbon, Portugal

belem_i_e_a4(portugal)

Documents

Transcript of belem_i_e_a4(portugal)