Basin Tap Aerator WBP Fitting Guide 28.05.15 · x1 24mm Male Tap Aerator and Regulator with 22mm...

2
www.everydropisprecious.com 01904 621 924 [email protected] 1 BASIN TAP AERATOR AND REGULATOR FITTING GUIDE (Measures 24mm Male AND 22mm Female) ABOUT THIS PRODUCT: This tap aerator and regulator has been designed to save you money by saving water and energy. This quality German manufactured aerator adds air into the water stream to create a seemingly voluminous, straight and non-splash stream. No need to change your whole tap! PARTS AND CONTENTS INCLUDED: x1 24mm Male Tap Aerator and Regulator with 22mm Female Adaptor with x2 rubber washers (simply unscrew the 22mm Female Metal Adaptor to reveal the 24mm Male thread) PREPARATION: Remove all parts from packaging and inspect for any transport damage prior to fitting. Make sure your tap(s) is turned off before you begin fitting. These fitting guidelines have been prepared to help you but you must exercise due care and attention at all times. We do not accept any responsibility for damage / problems that may occur through improper fitting or use. CLEANING: We recommend you clean your aerator & regulator from time to time, with a damp cloth to remove any scum or lime scale build up. N.B: using abrasive chemicals may cause damage and invalidate your warranty and as such we do not recommend these are used. TECHNICAL DATA: The basin aerator will perform from 0.2 bar water pressure – 6.0 bar, please note however that there will be differences in flow rates. WARRANTY: Contents are guaranteed for 2 years against any manufacturing defects. In the unlikely event that your pack contents break and/or are faulty within the 2 year warranty period through no fault of your own, please contact us directly.

Transcript of Basin Tap Aerator WBP Fitting Guide 28.05.15 · x1 24mm Male Tap Aerator and Regulator with 22mm...

 

www.everydropisprecious.com    01904  621  924  [email protected]   1  

BASIN TAP AERATOR AND REGULATOR FITTING GUIDE (Measures 24mm Male AND 22mm Female)

ABOUT THIS PRODUCT: This tap aerator and regulator has been designed to save you money by saving water and energy. This quality German manufactured aerator adds air into the water stream to create a seemingly voluminous, straight and non-splash stream. No need to change your whole tap! PARTS AND CONTENTS INCLUDED:

x1 24mm Male Tap Aerator and Regulator with 22mm Female Adaptor with x2 rubber washers (simply unscrew the 22mm Female Metal Adaptor to reveal the 24mm Male thread) PREPARATION: Remove all parts from packaging and inspect for any transport damage prior to fitting. Make sure your tap(s) is turned off before you begin fitting. These fitting guidelines have been prepared to help you but you must exercise due care and attention at all times. We do not accept any responsibility for damage / problems that may occur through improper fitting or use.

CLEANING: We recommend you clean your aerator & regulator from time to time, with a damp cloth to remove any scum or lime scale build up. N.B: using abrasive chemicals may cause damage and invalidate your warranty and as such we do not recommend these are used. TECHNICAL DATA: The basin aerator will perform from 0.2 bar water pressure – 6.0 bar, please note however that there will be differences in flow rates. WARRANTY: Contents are guaranteed for 2 years against any manufacturing defects. In the unlikely event that your pack contents break and/or are faulty within the 2 year warranty period through no fault of your own, please contact us directly.

 

www.everydropisprecious.com    01904  621  924  [email protected]   2  

STEP 1 of 2 Simply unscrew your existing regulator which you can find at the end of your tap spout. If stubborn, then use a tea towel and a pair of pliers to loosen.

STEP 2 of 2 Take new aerator & regulator with adaptor and check whether male or female screw thread is needed. You can simply unscrew the attached metal adaptor to reveal the male thread. A female thread is as the complete unit. Screw the aerator & regulator with rubber washer into the tap spout until tight. BEFORE AND AFTER FITTING:

For further help please see our fitting videos or contact us.