ba00bc0wf
description
Transcript of ba00bc0wf
7/17/2019 ba00bc0wf
http://slidepdf.com/reader/full/ba00bc0wf 1/3
BA00BC0WFLDO Regulator With Shutdown Circuit
BA00BC0WF is a PNP output LDO
regulator IC with the output current of 0.5A
and a voltage accuracy of ± 2%.
Output voltage can be set (1.5V to 12V) by
external resistor. Over-current protection
circuit and thermal protection circuit are
incorporated to prevent IC from being
damaged by short and thermal break down.
SOP8
Description Dimension (Unit : mm)
1) Maximum output current : 0.5A2) Output voltage setting by external resistor3) Low drop-out voltage(1.5V to 12V) type with PNP output
4) Built-in over-current protection circuit toprevent IC from being damaged by short
5) Built-in thermal protection circuit6) Built-in ON/OFF switch to realize the shutdown current 0uA7) SOP8 package8) C pin output voltage accuracy : ± 2%
Features
Printer, TV, DVD and Storage etc.
Applications
0 . 3
M i n .
0.15±0.1
0.4±0.1 0 . 1
1
6 . 2
± 0 . 3
4 . 4
± 0 . 2
5.0±0.2
8 5
41
1.27 1 . 5
± 0 . 1
0.1
7/17/2019 ba00bc0wf
http://slidepdf.com/reader/full/ba00bc0wf 2/3
Absolute Maximum Ratings (Ta=25˚C)
Supply voltage
Power dissipation
Operating temperature range
Storage temperature range
Parameter Symbol Limits Unit
*2 Mounted on 70mm x 70mm x 1.6mm glass-epoxy PCB Derating in done at 6.2mW/˚C for operating above Ta=25˚C*1 Do not however exceed Pd.
Vcc
Pd
Topr
Tstg
18
620
+85
+125
-40
-55
~
~
mW
˚C
˚C
Junction temperature Tjmax 125 ˚C
V
Application Circuit
Input voltage
Output current
VCC
Io
-
- -
3.0 16.0
0.5
V
A
Output voltage VOUT 1.5 - 12.0 V
Recommended Operating Conditions (Ta=25˚C)
Parameter Min. Max. UnitTyp.Symbol
Electrical Characteristics (Unless otherwise specified, Ta=25˚C, Vcc=3.3V, Io=150mA, R1=30kΩ, R2=30kΩ)
*2
*1
Parameter Symbol Min. Typ. Max. Unit ConditionsVctl=0V
Io=10mA
Io=150mA
Vcc=2.5V
f=120Hz, ein=-20dBV, Io=100mA
Vcc=4.5V→ 16V
Io=0mA → 500mA
Io=5mA, Tj=0~125°C
Io=0mA
Vcc=16VACTIVE MODE, Io=0mA
OFF MODE, Io=0mA
Vctl=3V, Io=0mA
ISD
Vc
Vo
∆Vd
Io
R.R.
Reg.I
Reg.L
Tcvo
Ib
IosVth1
Vth2
Iin
-
1.225
-
-
0.5
44
-
-
-
-
-2.0
-
40
0
1.250
2.50
0.18
-
55
20
50
±0.02
0.6
0.4-
-
80
10
1.275
-
0.30
-
-
50
150
-
-
--
0.8
130
µA
V
V
V
A
dB
mV
mV
% / °C
mA
AV
V
µA
• This product is not designed for protection against radioactive rays.
*1 Designed Guarantee.(Outgoing inspection is not done all products.)
* All characteristics are measured with a capacity across the input of 0.33µF and a capacity across the output of 0.22µF. Measurement is done at Ta Tj, and variations in the parameter of all measurement(expect Temperature Coefficient of Output Voltage)caused by temperature change are not considered.
*1
Vcc
GNDN.C.
CR2
R1
OUT
1
2.4
CTL8
6.7
Vref
3
5
BA00BC0WF
TSD
OCP
Shut down current
Vc pin voltage
Output voltage
Dropout voltage
Peak output current
Ripple rejection
Line regulation
Load regulation
Temperature coefficient of output voltage
Bias current
Short circuit output currentStand-by ON level
Stand-by OFF level
Input high current
7/17/2019 ba00bc0wf
http://slidepdf.com/reader/full/ba00bc0wf 3/3
This datasheet has been download from:
www.datasheetcatalog.com
Datasheets for electronics components.