Avengers Logo Magnet - PrusaPrinters · deadpool daredevil captain black avengers antman america...

2
1 hrs 1 pcs f 0.20 mm k 0.40 mm h PLA 19 g d MK3/S Summary You can glue a 10 x 1.5 mm round magnet in the base. Art & Design > 2D Plates & Logos xmen widow thor thanos strange starlord spiderman shield punisher panther of mcu marvel man iron hydra hulk guardians groot galaxy st doctor deadpool daredevil captain black avengers antman america Recommended inll angle: Low speed and high temperature will create a shiny top surface. There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind. If your top surface is not at & shiny and you see scarring, then make sure to check this guide: https://bit.ly/2UtN0I1 Synth3D Avengers Logo Magnet VIEW IN BROWSER updated 23. 4. 2019 | published 13. 4. 2019

Transcript of Avengers Logo Magnet - PrusaPrinters · deadpool daredevil captain black avengers antman america...

Page 1: Avengers Logo Magnet - PrusaPrinters · deadpool daredevil captain black avengers antman america Recommended infill angle: 0° Low speed and high temperature will create a shiny

1 hrs

1 pcs

f

0.20 mm

k

0.40 mm

h

PLA

19 g

d

MK3/S

Summary

You can glue a 10 x 1.5 mm round magnet in the base.

Art & Design > 2D Plates & Logos

xmen widow thor thanos strange starlord spiderman

shield punisher panther of mcu marvel man iron

hydra hulk guardians groot galaxy fist doctor

deadpool daredevil captain black avengers antman

america

Recommended infill angle: 0°

Low speed and high temperature will create a shiny top surface.

There are "holes" inside the model to make some of the top layers moreuniform, and they were created with 0.2 layer height in mind.

If your top surface is not flat & shiny and you see scarring, then make sureto check this guide: https://bit.ly/2UtN0I1

Synth3D

Avengers LogoMagnet

VIEW IN BROWSER

updated 23. 4. 2019 | published 13. 4. 2019

Page 2: Avengers Logo Magnet - PrusaPrinters · deadpool daredevil captain black avengers antman america Recommended infill angle: 0° Low speed and high temperature will create a shiny

Print Files (.gcode) DOWNLOAD ALL FILES

750.1 KB

1.17 hrs f 0.20 mm k 0.40 mm h PLA 19.00 g d MK3/S

updated 14. 4. 2019

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

4.0 MBupdated 14. 4. 2019

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution—Noncommercial—Share Alike

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition

avengers-logo.gcode

avengers-logo.stl