Page 1 of 2

ATV YAMAHA GRIZZLY 700Plow Mount Instructions Kit #60230

Tools: 9/16 wrench (2) Ft. lbs. torque wrench with 9/16 socket Protective eyewear

Plow Mount PartsLock Nut (4x)

1

a) Position rear bracket with rear of mount plate as shown and assemble with one long bolt, flat washer and lock nut, turn finger tight. (NOTE: Notched side of rear bracket points down facing to-wards front)

b) From side of machine at front of frame, orientate front bracket as shown and insert it across top of frame.

c) When done, bracket should nestle on top of machine frame as shown.

2

a) Under rear of machine, from side as shown insert rear bracket on mount plate across top of rear frame tubes (and under drive shaft) until open hole in bracket extends on outside of frame on opposite side.

b) Then insert another long bolt bottom up through mount plate and into rear bracket, place flat washer and turn lock nut finger tight. (Photo taken from left side of machine)

c) Shows rear bracket nestled on top of rear frame and under drive shaft with nuts finger tight on both sides. (Photo taken from right side of machine)

(continued on back)

Flat Washer (4x)

Top Bracket (front)

Mount PinReceiver

Short Bolts (2x)Pin Clip Long Bolts (2x)

Mount Plate

Top Bracket (rear)

Long bolt, flat washer, lock nut Notch in

rear bracket

Rear ofmount plate Front Bracket

Rear bracket over hanging - typical on both sides

1st bolt in bracket and mount plate

2nd bolt in bracket and mount plate

Drive shaft

Rear bracket

Notched side faces

forward

PN 50365_A ©Copyright 2013 Agri-Cover, Inc. All Rights Reserved 081613

3

a) At front of machine, lift front of mount plate up and insert short bolt bottom up through mount plate and into hole on front bracket. Then use flat washer and turn lock nut on finger tight. Insert an-other short bolt, flat washer and finger tight lock nut on opposite side.

b) Using 9/16 wrenches, tighten both front bolts snug tight for now.

c) Then tighten both rear bolts snug tight. (9/16 size wrenches) Now torque each front bolt to 31 ft. lbs. Then torque each rear bolt to 31 ft. lbs.

(continued from front)

4

a) Insert rear prong on receiver tube into notch on rear of mount plate.

b) Lift front of receiver up and insert re-ceiver pin through holes of receiver and mount plate.

c) Insert hitch pin clip into receiver pin. In-stallation is now complete. Periodically check bolts and retorque if needed.

Lift front of plate up

Insert prong into notch

Hitch pin

Hitch pin clip

Page 2 of 2