Assembly Directions for Adirondack Chair
2
Assembly Directions for Adirondack Chair #PATC2400 HARDWARE PACKAGE 2 ¼" x 2½" Lag Bolts 4 ¼" x 3½" Allen Head Bolts 4 2½" Screws 4 ¼" Flange Nuts 1 Allen Wrench TOOLS NEEDED: 7 /16" Wrench Cordless drill/Screwdriver #2 Square Drive Bit Allen Wrench (Included) Hammer PACKAGE CONTENTS 1 Seat 2 Arm Assemblies 1 Back 1 Hardware Package Firmly tap bolts into pre-drilled holes before tightening. CORRECT INCORRECT 1 2 3 4 5 Use to measure bolts Left Arm Right Arm Seat Support Front Crosspiece Seat Slat Curved Seat Slat (not visible) Leg Back Slat Arm Support
Transcript of Assembly Directions for Adirondack Chair
Assembly Directions forAdirondack Chair
#PATC2400
HARDWARE PACKAGE2 ¼" x 2½" Lag Bolts4 ¼" x 3½" Allen Head Bolts4 2½ " Screws4 ¼" Flange Nuts1 Allen Wrench
TOOLS NEEDED: 7/16" Wrench
Cordless drill/Screwdriver#2 Square Drive Bit
Allen Wrench (Included)Hammer
PACKAGE CONTENTS1 Seat 2 Arm Assemblies1 Back 1 Hardware Package
Firmly tap bolts into pre-drilledholes before tightening.
CORRECT INCORRECT1 2 3 4 5Use to measure bolts
Left ArmRight Arm
Seat Support
Front Crosspiece
Seat Slat
Curved Seat Slat
(not visible)Le
g
Bac
k Sl
atArm Support
¼" x 3½" Allen Head Bolts
¼" x 3½" Allen Head Bolts
¼" x 2½" Lag Bolt
2½" Screws
STEP #1 - Fasten the seat and the Arm Assemblies using two ¼ " x 3½ " Allen Head bolts.
STEP #3 - A. Fasten arm assembly to the back using one ¼ " x 2½ " Lag Bolt.B. Fasten Back to the Seat using two 2½ " Screws. Place bottom Back Support in routed slot behind last seat slat for placement. (See picture.)
STEP #2 - Lay the chair on the other side and repeat Step 1.
STEP #4 - Your Adirondack chair is complete!
