Arizer Solo Battery Replacement Instructions

1. Remove four screws from the bottom of the unit.You will need a very small Phillips screwdriver (#00).

2. Slide the top cover up and remove it from the unit.You may need to slightly pry it away from the bottom.

2. Using a small flat tip screwdriver, carefully pry open the battery compartment cover tabs on both sides of the unit (4 total), while pushing the cover away from the unit.

Page 1

Arizer Solo Battery Replacement Instructions

4. Remove old battery from the unit.Disconnect the battery by pulling apart the connector. Do not pull on the wires!!!

Page 2

5. Connect new battery to the unit.

6. Power on the unit to make sure that it works. Power off the unit.

Arizer Solo Battery Replacement Instructions

7. IMPORTANT!!!. New battery orientation:Connector side should be on the bottom of the unit, flat side should be on top.

Page 3

9. Carefully push the top of the battery into the unit. The replacement battery is slightly longer than the original one. It should fit very snuggly into place.

TOP

Bottom First

BOTTOM

8. Insert the bottom of the new battery into the unit.

Arizer Solo Battery Replacement Instructions

10. Reinstall the battery cover. If it proves too difficult to snap it into place, it may be safely left out.

11. Slide the unit back together and secure the bottom with four screws removed in step 1.

Page 4

Original vs Replacement battery comparison.