Cycle switchMain power switchDrain switchWater softener switch

Salt containerWash pump filterCombined wash and rinse armDrain plug hole

Drain plugDrain filter

Cycle lightPower lightReady lightWater softener light

To switch the machine on· Fit drain filter and drain plug into drain plug hole· Close the dishwasher door· Switch on the main power switch, the dishwasher will now fill

and heat. The dishwasher is ready to use when the ready light is illuminated.

· Press the cycle switch for 2 seconds, the cycle light will illumi-nate, after the cycle light goes out the cycle is complete.

To drain the dishwasher· Switch of the main power switch· Remove the drain plug LEAVE THE DRAIN FILTER IN

PLACE.· Press the white drain switch for 2 seconds, the drain pump will

run for 2 minutes to drain the machine.· Clean out the dishwasher including the drain filter.

Water softener regeneration· With the dishwasher drained and clean remove the salt container

lid· Pour in 1 mug full of dishwasher salt and replace lid.· Close the dishwasher door· With the main power switch off, press and hold the water sof-

tener switch for 3 seconds, the water softener will then go through a regeneration cycle, this is indicated by the water sof-tener light illuminating. This will take 20 minutes.

· THE WATER SOFTENER MUST BE REGENERATED EVERY DAY.