ARDUINO UNO R3 POWER SUPPLY

PRODUCT LINK: https://www.robomart.com/battery-chargers-adaptors-eliminators

BY ROBOMART

INTRODUCTION:• The Arduino Uno R3 Power supply is a microcontroller board based on the ATmega328P. 

• It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. • It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC- to-DC adapter or battery to get started..

• You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

Continue……

• In this modern technology, whether electronic, mechanical or electrical all of these require some backup. • For backup, inventions reached to batteries which worked for longer hours depending upon device which requires more power.

• If power required is more, battery will be dead within few hours and vice versa. There exist two types of batteries disposable and rechargeable. In rechargeable, battery is charged when dead and in disposable battery, cells once dead can’t be used again.

Continue…

• Battery eliminators and battery adapters have replaced use of batteries.

• Instead of utilizing battery, it’s better to use eliminators because when connected provide power to your electronic items.

• It’s used in number of devices especially electronic circuits and caters 9volt DC supply.

• We have maintained a renowned approach towards eliminators and powerful battery chargers in India. So without any doubt, quickly grab opportunity and purchase battery as per requirements.

HOW IT LOOKS:

CONTACT US:

•B5, C-Block, Above IOB Bank, Sec-31,Noida-201301(UP) India

•0120-4317229•+91-8744000555•admin@robomart.com•www.robomart.com

THANK YOU