Arc de Tri i e a4
-
Upload
ronald-balmaceda -
Category
Documents
-
view
213 -
download
0
Transcript of Arc de Tri i e a4
8/13/2019 Arc de Tri i e a4
http://slidepdf.com/reader/full/arc-de-tri-i-e-a4 1/3
1
2
4
http://www.canon.com/c-park/en/
Arc de Triomphe, France: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe
Assembly Instructions
Mountain fold(dotted line)Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)Cut along the line.
Cut in line(solid line)Cut along the line.
Glue spot(Red dot)Glue parts with the same number together.
Glue spot(Green dot)Glue within the same part.
Glue spot(Blue dot)Glue to the rear of the other part.
Glue
The glue spot(colored dot)shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, usedballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young childrenso be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions:Three A4 sheets(No.1 to No.3)*This model was designed for Papercraft and may differ from the original in some respects.
*Hint: Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Indicates where sections shouldbe glued together.
Before starting assembly:Writing the number of each section on itsback side before cutting out the sections is highly recommended.(* This way, you can be sure which section is which even after cutting outthe sections.)
1(Front)
3(Rear)
3(Rear)
Fold part 2 inward along the fold lines.Apply glue to the rear surface of theparts folded in.Part 2 has a front and a rear side.Be careful to assemble the parts correctly,as shown in the illustrations.
Glue parts 1, 2, and 3 along the top.
Parts (1 + 2 + 3)
Underside of parts (1 + 2 + 3)
8/13/2019 Arc de Tri i e a4
http://slidepdf.com/reader/full/arc-de-tri-i-e-a4 2/3
2
5, 6, 7, 8
5
67
8
10
12
14
15
11
13
9
Arc de Triomphe, France: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe
Top
Bottom
Cross-section of partsafter gluing
Be careful to avoid confusingtop and bottom when gluing.
8/13/2019 Arc de Tri i e a4
http://slidepdf.com/reader/full/arc-de-tri-i-e-a4 3/3
18, 19, 20, 21,
22, 23, 24, 25
16
17
18
24
23
22
25
21
20
19
26
Arc de Triomphe, France: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe
Top
Bottom
Cross-section ofparts after gluing
Don't forget to cutalong these lines.
Be careful to avoid confusingtop and bottom when gluing.
Finished!
3