Comparative Evaluation of Antimicrobial efficacy of 0.2% ...
Antimicrobial Efficacy Comparison of Floor Coverings...multiple bacteria, mould and yeast....
Transcript of Antimicrobial Efficacy Comparison of Floor Coverings...multiple bacteria, mould and yeast....
Beth Joiner is Manager of TechnicalSales and Services for the Georgia
Laboratory of North AmericanScience Associates, Inc. (NAMSA). She
is responsible for advising clientson technical matters, preparation of
routine and non-routine costestimates and proposals and
providing technical education,training and orientation to clients.
Ms Joiner has 24 years ofexperience in the field of
microbiology – four years withCustom Biologics and the Murray
State University Diagnostic andResearch Center and 20 years with
NAMSA. She is a member of theAssociation for the Standard Testing
of Materials (ASTM) and theAmerican Association of Textile
Chemists and Colorists (AATCC) RA31Antimicrobial Test Methods
committee and the American Societyof Microbiology (ASM). Ms Joiner isa registered microbiologist with theNational Registry of Microbiologistsin the area of consumer products
and quality assurance microbiology,pharmaceutical/medical devices/cosmetics. She has published an
article on determining antimicrobialefficacy in Nonwovens Industry
Magazine and wrote a chapter,“Determining Antimicrobial Efficacy
and Biocompatibility of TreatedArticles Using Standard Test
Methods”, in the American ChemicalSociety (ACS) Symposium Series 792
Bioactive Fibers and Polymers. MsJoiner holds a BSc Degree in
Biological Sciences from MurrayState University.
a report by
B e t h J o i n e r
Manager, Technical Sales and Services,
Georgia Laboratory of North American Science Associates, Inc. (NAMSA)
The purpose of this article is to determine which floorcovering performed the best when challenged withmultiple bacteria, mould and yeast. Antimicrobialefficacy testing was performed on four floor-coveringsamples: homogeneous polyvinyl chloride (PVC)sheet; medical-grade soft surface floor; linoleum sheetmaterial with two coats of acrylic floor sealer and twocoats of acrylic floor finish; and linoleum sheetmaterial with factory finish.
The American Association of Textile Chemists andColorists (AATCC) test method 100 was the testmethod used to determine antimicrobial efficacy ofthese floor coverings. This method provided aquantitative procedure to evaluate the antimicrobialactivity and provided bactericidal data. The standardtest method normally uses two test organisms,Staphylococcus aureus and Klebsiella pneumoniae.However, for the purpose of this study, the followingorganisms were used as challenge organisms: fivebacteria, Staphylococcus aureus American Type CultureCollection (ATCC) 6538, Klebsiella pneumoniae ATCC4352, Pseudomonas aeruginosa ATCC 9027, Salmonellacholeraesuis ATCC 10708 and Bacillus cereus ATCC11778, both vegetative and spores; two fungi,Aspergillus niger ATCC 16404 and Stachybotrys chartarumATCC 9182; and one yeast, Saccharomyces cerevisiaeATCC 9763. A sample size of 48mm disc was cut foreach test organism and sample type. The test samplewas inoculated with a population of (1-2) x 105
colony-forming units per 0.1ml. The inoculum wascovered with a piece of sterile film to allow intimatecontact of the flooring surface with the test organism.One container with each floor type and each testorganism was incubated for 24 hours. The bacteriawere incubated at 37ºC±2ºC and the mould and yeastat 28ºC±1ºC. Duplicate containers of each floor typeand each organism were tested to determine thepopulation at zero time. Population at zero time wasdetermined by adding a neutraliser solution to eachcontainer and plating serial dilutions. The serial dilu-tion plates were incubated at 37ºC±2ºC for 48 hoursfor bacteria and 28ºC±1ºC for the mould and yeast.
The test containers that were incubated for 24hours were removed from their respectiveincubators and the population of any remaining
viable organisms was determined by adding aneutraliser solution to each container and platingserial dilutions. The serial dilution plates wereincubated at 37ºC±2ºC for 48 hours for bacteriaand 28ºC±1ºC for the mould and yeast.
All plates, both zero exposure time and 24-hourexposure time, were counted using a Quebec® ColonyCounter. The per cent reduction of bacteria, fungi andyeast for each test sample was calculated by taking theaverage of the zero time count plus the count of theinoculum concentration and divided by two. Next, thecount of each bacteria, fungi and yeast per sample fromthe 24-hour plates is subtracted from that average andthat number is divided by the average and multipliedby 100 to get per cent kill. The test results show thateach of the test samples mentioned, with the exceptionof the homogeneous PVC sheet, showed greater than99% reduction against non-spore-forming bacteria.One exception, other than the homogeneous PVCsheet, was the medical-grade soft surface floor thatdemonstrated a poor reduction against the gram-negative Pseudomonas aeruginosa. The spore-formingBacillus cereus showed good reduction in the vegetativestate for all samples except the homogeneous PVCsheet. The spore state of Bacillus cereus showed goodreduction for all samples except the homogeneousPVC sheet and moderate reduction for the linoleumsheet material with two coats of acrylic floor sealer andtwo coats of acrylic floor finish. The fungal results,specifically looking at the fungal count after 24 hours,compare very closely for all samples except thehomogeneous PVC sheet. The test results for the yeastalso compare very closely for all samples except thehomogeneous PVC sheet when looking specifically atthe yeast count after 24-hour contact.
In summary, the homogeneous PVC sheet was theonly test sample that consistently showed noeffectiveness against any of the challenge organisms.The medical-grade soft surface floor showedconsistent results against bacteria but was not aseffective in the kill of yeast and fungi. However, theother linoleum sheet material samples presented verycomparable results and show that they prevent thegrowth of bacteria, both vegetative and spore-formers, as well as yeast and mould. ■
Ant imic rob ia l E f f i cacy Compar i son o f F loor Cover ings
52
Infection Control & Sterilisation FLOORING
B U S I N E S S B R I E F I N G : H O S P I T A L E N G I N E E R I N G & F A C I L I T I E S M A N A G E M E N T 2 0 0 4
joiner_pap.qxd 23/12/03 11:13 Page 52
When there’s a hundred things on your mind,make sure there’s only one thing on your hands
www.regentantiseptics.comRegent Medical, Canute Court, Knutsford, Cheshire WA16 0NL. Tel: 01565 625174. Fax: 01565 625197. The Hibi range, Regent, the Regent logo and the tick are Trade Marks of the SSL group.
The new look range of Hibi antisepticsOne less thing to worry about
Regent_Hibiscrub_ad.qxd 18/12/03 13:26 Page 53