LTE Antenna Installation, Positioning and Selection Guide for ISR ...
Antenna Positioning System - sa-solutions.com · Antenna Positioning System ... that works with...
Transcript of Antenna Positioning System - sa-solutions.com · Antenna Positioning System ... that works with...
Automatic Alignment and Peaking System
Antenna Positioning
System
Superior Access Solutions, Inc. introduces its full antenna positioning system (APS) that works with Pan-Tilt positioners to automatically align mobile antennas with a fixed tower site. This system utilizes a single board computer that executes the control algorithm and controls the tilt and azimuth of the locally connected positioner. The system is housed in a 1RU chassis and user control is accomplished using a simple intuitive LCD display. Auto-peaking is supported via an SNMP-enabled interface to the microwave radio.
The system is designed to be compliant with a number of off-the-shelf positioning systems and microwave radios. Currently, the APS supports the following end-hardware:
• Simplifies establishing RF links from 0 - 10 miles
• Easy to interpret link statistics
• Cost-effective modular design allows system to work with a variety of equipment
• Uses SNMP and IP communications for system control
FEATURES & BENEFITS
Tel 1.952.469.887421037 Heron Way, Lakeville, MN 55044 www.sa-solutions.comPUBLISHED DATE: MARCH 2013
Information furnished by SAS is believed to beaccurate and reliable. No responsibility is assumedby SAS for its use. Specifications are subject tochange without notice. Superior Access Solutions, Inc 2013. ALL RIGHTS RESERVED
APS Processor - 1RU rack-mounted enclosure containing the single-board processor, VHF radio, and GPS module.
Radio - These indoor/outdoor units are frequency agile providing availability in the most commonly used licensed and unlicensed frequencies. Commmunication between the radios and APS is accomplished via SNMPv3 with authentication and privacy encryption.
Positioner - Moog/Quickset QPT and QPT--RF series supporting Quickset QPTR-96 protocol.
Technical Specifications
SAS PROCESSOR
POWER SUPPLY 100-240VAC/50-60 Hz Universal Input
NETWORK PORTS (2) 10/100/1000 Mbps Gigabit Ethernet Ports
COMPASS INTERFACE RS485
PAN/TILT INTERFACE RS485
PHYSICAL SPECIFICATIONS Dimensions (W x D x H) 483 x 220 x 43mm (19” x 8.7” x 1.7”)
MANAGEMENT Front Panel LCD display Web Based Configuration Optional SAS EMS (POINT System)
SUPPORT Standard: Business Hours M-F 8AM-5PM CST Premium: 24 hours x 7 days/week
Tel 1.952.469.887421037 Heron Way, Lakeville, MN 55044 www.sa-solutions.com
QUICKSET QPT-90 POSITIONER
LOAD CAPACITY 90 lb-ft (122 Nm) maximum
OPERATING VOLTAGE RANGE 24VDC (+/- 4VDC)
PAN-AXIS RANGE 360º continuous rotation (slip ring)
TILT-AXIS RANGE 180º (+/- 90º)
TILT-AXIS SPEED 0.005º - 25º/sec
OPERATING TEMPERATURE Without Heater: -15ºC to 55ºC (5ºF to 131ºF) With Heater: -30ºC to 155ºC (-30ºF to 131ºF)
MOTOR TYPE/DRIVE Stepper (Sentry)
COMMUNICATION TO PAN & TILT RS232/422/485, IP Ethernet, 10/100 Base-T
COMMUNICATION TO SENSORS RS232/422, Ethernet Pass-Through
CONTROL PROTOCOL Moog QuickSet PTCR-96
WEIGHT 37 lbs (16.6 kg) to 75 lbs (34 kg) depending on model
OPERATING VOLTAGE RANGE 24VDC (+/- 4VDC)
RADIO
PAYLOAD Ethernet: 20/50/100/150/200/240/250/ 300/335/400/500/600/670 Mbps T1/E1: 0/2/16/32/37/42/63 OC-3/STM-1: Up to 3xOC-3/STM-1 per IDU
PHYSICAL INTERFACES Ethernet: 4xRJ-45 10/100/1000Base-TX, SFP T1/E1: 2xRJ-48c
MANAGEMENT Remote Access SNMP Full Featured MIB Web-Based GUI Telnet - Command Line Interface Interface 2x10/100 Base-TX, RJ-45
Local Access Serial - Command Line Interface Interface: HDB-15
Alarms Input: 4xTTL-level Output: 2x Form C contacts, 2x TTL-level InterfaceL HDB-15
Topology Out-of-Band Management with embedded 2x 10/100 switch allows ring and cascaded network management topology
RSL Measurement Voltage output at ODU with BNC Interface and Web-GUI
ENVIRONMENTAL Indoor Unit Operating Temperature: -5º to +55ºC Relative Humidity: 0 to 95%, non-condensing Altitude: 4,500 m Outdoor Unit Operating Temperature: -33º to +55ºC Relative Humidity: 0 to 100% Altitude: 4,500 m
MECHANICAL Indoor Unit Size: 17.5W x 9.4D x 1.8H (1RU) Weight: 10.1 lbs
Outdoor Unit: Size:10.5 diameter x 3.5 inches deep Weight: 10.1 lbs
POWER Input Voltage -48VDC: -36 to -72 VDC Interface: 2 Pin Phoenix Contact Power Consumption 1+0: 76W 1+1/2+0: 137W