anita IP67 LED in grade uplight, recessed wall mount CSA listed wet label

ANI 2/118

52211_Anita.indd 1 2/7/11 12:56 PM

2 | d e s i g n p l a n / A R E S

De

sig

n b

y A

res

co

nc

ep

t - te

ch

nic

al m

an

ag

er:

en

g. D

avi

de

Ca

valli

ANITA

52211_Anita.indd 2 2/7/11 12:56 PM

d e s i g n p l a n / A R E S | 3

De

sig

n b

y A

res

co

nc

ep

t - te

ch

nic

al m

an

ag

er:

en

g. D

avi

de

Ca

valli

Anita

• DescriptionRecessed luminaire for outdoor installation on ground and wall. Configuration: extruded and turned anodized-aluminium heat sink hosting the power led. Opal or transparent polycarbonate diffuser with silicone gasket and anodized aluminium cap or frame. The base of the luminaire is sealed with polyurethane resin. CSA Listed. complies with LM79 and LM80

• Versions availableDiffuser and frame:- Semispherical opal polycarbonate diffuser. - Flat opal or transparent polycarbonate diffuser with anodized-aluminium frame.- Flat transparent polycarbonate diffuser with anodized aluminium cap for side-emission.Power supply:- Constant current 350mA feeding – constant voltage (12-24V DC) feeding on request.

• Light sources1-led module 1W/constant current 350mA - cool white 6000°K, warm white 3000°K, blue 475nmAccessories on request:- Constant current 350mA power supply- Constant current 350mA dimmable power supply

• Dimensions- Semispherical and side-emission: Ø 1.34” _ recessing depth including box for installation: 2.75”- Flat diffuser with frame: Ø 1.42” _ recessing depth including box for installation: 2.75”- Box for installation: Ø 2.75” _ recessing depth: 2.75”

• Technical featuresProtection Rating: IP67 - In compliance with EN 60598-1 -

• InstallationAnita is equipped with a piece of bipolar cable (.75”) for an easy-to-make connection. The only connection allowed is “in series”. The only power supply allowed is a constant current I=350mA electronic power supply. The installation requires a dedicated box for installation. Accessory on request: box for installation

An efficient drainage of water with a layer of gravel should be forseen - 8” deep.

The feeding power supply (I out 350 mA) for low voltage must be installed on remote position.

The fixture must not be installed in hollow areas.

The fitting is equipped with 1 cable input

Recessed wall fitting

.8 anodized aluminium

Maximum load(pedastrian traffic):880 lbs

Protection againstimpact.IK 09 - 10,00 joule

IP67 CSA

d e s i g n p l a n / A R E S | 3

52211_Anita.indd 3 2/7/11 12:56 PM

4 | d e s i g n p l a n / A R E S

U11487721 COOL WHITE LED 1W 350mA

U114145721 BLUE LED 1W 350mA

U114144721 WARM WHITE LED 1W 350mA

ALUMINIUM FRAME

1X 1X 1X

1X 1X 1X

1X 1X 1X

U11487121 COOL WHITE LED 1W 350mA

U11487231 COOL WHITE LED 1W 350mA

U114145121 BLUE LED 1W 350mA

U114145231 BLUE LED 1W 350mA

U114144121 WARM WHITE LED 1W 350mA

U114144231 WARM WHITE LED 1W 350mA

1X 1X 1X

1X 1X 1X

1X 1X 1X

1X 1X 1X

1X 1X 1X

1X 1X 1X

40°

WIDE BEAM10°

NARROW BEAM

40°

WIDE BEAM10°

NARROW BEAM

40°

WIDE BEAM10°

NARROW BEAM

40°

WIDE BEAM10°

NARROW BEAM

40°

WIDE BEAM10°

NARROW BEAM

40°

WIDE BEAM10°

NARROW BEAM

opal diffuser

transparent diffuserdiffusore trasparente

ANITA

52211_Anita.indd 4 2/7/11 12:56 PM

d e s i g n p l a n / A R E S | 5

U11487001 COOL WHITE LED 1W 350mA

U114145001 BLUE LED 1W 350mA

U114144001 WARM WHITE LED 1W 350mA

1X 1X 1X

1X 1X 1X

1X 1X 1X

opal diffuser diffusore opale

ANITA

52211_Anita.indd 5 2/7/11 12:56 PM

6 | d e s i g n p l a n / A R E S

ALUMINIUM FRAME-SIDE EMISSION

U11487351 COOL WHITE LED 1W 350mA

U114145351 BLUE LED 1W 350mA

U114144351 WARM WHITE LED 1W 350mA

1X 1X 1X

1X 1X 1X

1X 1X 1X

U122BOX FOR INSTALLATIONø2.64” x H2.75”

transparent diffuser

ANITA

52211_Anita.indd 6 2/7/11 12:56 PM

d e s i g n p l a n / A R E S | 7

Power suppliesCatalog number Description Capacity

PPLT00109 120V 350mA 1-8 FIXTURES NON DIMMABLEPPLT00110 120-277V 350mA 4-12 FIXTURES NON DIMMABLEPPLT00208 120V 350mA 3-12 FIXTURES TRIAC DIMMABLE

Note: Anita fixtures are constant current and must be wired in series.

52211_Anita.indd 7 2/7/11 12:56 PM

79 Trenton Avenue • Frenchtown, NJ 08825 • Tel: (908) 996-7710 • Fax: (908) 996-7042 www.designplan.com

The products shown in this catalog are designed and engineered by Willy Meyer + Sohn. They are assembled under license by Designplan Lighting, Inc.

52211_Anita.indd 8 2/7/11 12:56 PM