When the Wanaka Ale House wanted to create a different and striking finish to their construction in Wanaka they looked to EuroPanel.®

Its striking look and colour created a signature presence in its lakeside position. EuroPanel® is available in both cooper and zinc and will provide a stunning finish to any property

EuroPanel® creates a finish that will make your project stand out from the rest

EuroPanel® in Copper

Wanaka Ale House, Wanaka

Euro

Pan

el®

Zealand Building Code and material warranty, especially in areas not naturally rain washed.

Profile Drawing

SpecificationsBMT Material Nominal Weight/lineal metre (kg/m)

0.70mm Copper 6.78

0.70mm Zinc 3.02

EuroPanel® a wall cladding only product, is a lightweight solution, which produces a high-level aesthetic finish. Used on a number of installations, including retail and residential.

Installation

EuroPanel® wall cladding must always be installed over a plywood (12mm minimum) substrate with a moisture content of less than 18% and made wind tight, with purlin supports underneath at 600mm centres in low to high wind zones and 400mm centres for very high and extra high wind zones. Avoid contact between Zinc and Bitumous papers.

Building Code Compliance

The product will, if employed in accordance with the supplier’s installation and maintenance requirements, assist with meeting the following provisions of the building code for a period of 15 years:

• Clause B2 Durability: Performance B2.3.1

• Clause E2 External moisture: Performance E2.3.1, E2.3.2

• Clause F2 Hazardous building materials: Performance F2.3.1

Additional Profile Information

Available in the following materials:

• Copper

• Zinc

Available as either Lock Seam or Hook Seam

Notes: Please consult with a Dimond® Representative before ordering for:

1. The correct coat to suit your cladding to match the environment.

2. Availability of any non standard colours, materials or thicknesses.

Maintenance must be carried out on your cladding to ensure the roof meets the required durability according to the New

EuroPanel®Residential and Commercial

NOTES1. Loads given are limited to a maximum of 4.15kPa. If design requirements exceed this limit,

Contact Dimond Roofing® for specific advice.

2. Design Criteria for Limit State Capacities a) Ultimate Limited State No pull through of fixings or fasteners withdrawal resulting in sheet detachment due to wind

up-lift (outward) loads

3. Wind Pressure Guide As a guide for non-specific design the following S.L.S. design loads in accordance with the MRM

Roofing Code of Practice can be used for buildings less than 10m high, otherwise AS/NZS 1170.2 should be used

Low wind zone = 0.68kPa, Medium wind zone = 0.93kPa, High wind zone = 1.32kPa, Very high wind zone = 1.72kPa and Extra high wind zone = 2.09kPa.

This product must be installed by a certified and approved RoofingSmiths installer. See roofingsmiths.co.nz

V0

1.0

3.0

119

To be used as a wall cladding only.

0800 DIMOND dimond.co.nz

December 2018

Lock Seam Hook Seam

W

H

W

H

Panel Tolerances

Cover (mm) H = 600 x W = 1125 Dimensions given are nominal

Panel length ‡ 5mm

Panel Height ‡ 5mm