1

Crochet Tips Toilet paper cover: With color #86 (spring green), ch17 to cast on, then work in hdc. Starting from second row, change to color #82 (light cream) and work 16 rows. Work row 17 in color #86, and work edging in color #82. Attach motifs, and sew cotton and rubber tapes to wrong side.

Toilet paper holder: Start as for cover; work in hdc per schematics. Attach motifs and cotton tape.

Slippers: Work sole in sc according to schematics with two strands of color #82. With one strand of color #86, work instep as follows: ch30 to CO and crochet per schematics. Using color #82, sew instep to sole with backstitch; attach motif.

Toilet rug: ch90 with color #82 to CO; work in hdc. While changing colors according to chart, work 50 rows. Leaving middle 38 sts unworked, split and work 18 rows for right and left sides separately. With wrong side of rug facing, work 1 round of sc edging with color #86, then work 2 rounds of loop stitch. Attach motifs in 8 places.

Flower motifs: Create magic ring, ch1 for turning post, and crochet per schematics.

Abbreviations: ch = chain; CO = cast on; hdc = half double crochet (US); m = magic ring; sc = single crochet (US); tog = together

amikomo3-27 Bathroom Set © Pierrot Yarns (Gosyo Co., Ltd.). Translation by Linda Lanz.

Materials • Pierrot Yarns Yuttari Acrylic [100% antibacterial deodorant acrylic; 73

yds/67m per 1.41 oz./40g skein]; • color #82 light cream; 8 skeins [290g] • color #86 spring green; 3 skeins [100g] • color #87 light red brown; 1 skein [30g]

• 3.5mm (US E) crochet hook or size necessary to achieve gauge • 70cm/27.56" length of cotton twill tape (12mm/0.47" wide) • 16cm/6.30" length of rubber tape (8mm/0.31" wide)

Gauge • half double crochet (US): 17 sts and 13 rows = 10cm/4" square

Finished measurements • toilet paper cover:

• holder circumference 48cm/18.90" • holder width 15cm/5.91" • cover length 12cm/4.72" • cover width 15cm/5.91"

• toilet rug: • height 55cm/21.65" • width 57cm/22.44"

• bathroom slippers: • foot length 24cm/9.45"

2

Attach cotton tape to prevent stretching. Attach rubber tape on top of that (fold rubber tape 1.5cm/0.59" from edge; sew down).

Tie cord/tape; mount to toilet paper holder.

3

With color #82, sew instep to sole with

blindstitch.

4

Make 12 motifs with color #87 (light red brown): • TP holder: make 2 • slippers: make 2 • toilet rug: make 8

5

See note 1 below.

edging (color #86): with wrong side facing, sc414

around circumference. On rounds 2-3, work loop st.

Note 1: These two times only, work 1 sc instead of 2 sc into same stitch. (In other words, work where is expected.)

(applies to both left and right sides of rug)