Alex Chapman, Jackie Pates & Hao Zhang PGR poster... · 2019. 12. 18. · Understanding the...
Transcript of Alex Chapman, Jackie Pates & Hao Zhang PGR poster... · 2019. 12. 18. · Understanding the...
Assessing the Aging Effect on the Biovailability of Selenium-79 and Technetium-99 in soils using the Diffusive Gradients in Thin-Films Technique (DGT)
Alex Chapman, Jackie Pates & Hao Zhang
(1) Introduction & Rationale
(2) Approach
(3) Results
(4) Conclusions
Selenium-79 (79Se) and technetium-99 (99Tc) have been identified as significant radionuclides in long-term safety assessments of nuclear waste disposal owing to their long half-life ( ≥105 years) and high mobility.
Understanding the bioavailability of these radionuclides and how they age within different soil types is crucial in order to evaluate their potential transfer from the soil and their incorporation into the biosphere. Entry
into the biosphere would occur as a result of plant uptake in the event that these radionuclides become mobilised within the soil following disposal of nuclear waste in deep geological repositories, or due to aerial
deposition. Once taken up by plants there is then significant potential for redistribution throughout the food chain which can ultimately lead to human consumption of contaminated agricultural produce and livestock.
Figure 1. (Above) Schematic diagram showing
cross-section through DGT device during soil
deployment along with the established
concentration gradient.
Organic carbon is the dominant soil property influencing the availability of both Tc and Se.
The aging of both Tc and Se can be described well by a pseudo-second-order equation. Tc ages faster in soils of higher organic carbon content. Se ages faster in soils of higher organic carbon and in particular
soils with a higher content of Al + Fe. Tc ages faster in soils of higher organic carbon.
Twenty soil samples encompassing a range of properties and land use types were artificially spiked in the laboratory
with selenium (Se) Tc and U. The soils were incubated in the dark at 10-14°C, with DGT deployments made at
progressively-increasing time intervals throughout the incubation period (Figure 2). For the DGT deployments, the soils
are wetted to saturation and subsequently returned to an air-dry state.
3.1. Technetium
How does DGT work?
Based upon the principles of Fick’s first law of diffusion, it acts as sink to promote the continued diffusion of a target element across a well-defined diffusion
pathway (see Figure 1).
Rapid immobilisation of kinetically labile or available species occurs through a selective binding agent within the binding layer (A; Figure 1). A polyacrylamide
diffusive gel layer (B) is interposed between the binding layer and filter membrane (C) to constrain the flux.
Elements are eluted from the binding layer using a suitable acid prior to quantitative analysis.
Figure 2. (Left) DGT deployment in incubated soil sample.
Why DGT?
Conventional extraction techniques for assessing availability have a number of inherent limitations and uncertainties. E.g. their reproducibility and comparability have
been questioned and there is the possibility of induced changes in speciation during the extraction procedure. They are based on an equilibrium approach to
determining exchangeable soil fractions, yet the soil system is a complex dynamic system where a variety of processes operate as sources and sinks such that it is never
in a state of true equilibrium.
DGT offers an in-situ kinetic approach to determining availability by perturbing the soil system in the same manner as a plant would by mimicking the rate of removal of
an element by a plant. A number of studies have demonstrated significant linear relationships between DGT uptake and plant uptake for a range of trace elements and
plant types.
A B C
0
0.2
0.4
0.6
0.8
1
1.2
0 50 100 150 200 250 300 350 400 450 500 550
No
rmal
ise
dav
aila
bili
ty
Aging time (days)
0
0.2
0.4
0.6
0.8
1
1.2
1.4
1.6
1.8
0 50 100 150 200 250 300 350 400 450 500 550
No
rmal
ise
dav
aila
bili
ty
Aging time (days)
3.2. Selenium
• A significant (p < 0.05) relationship was observed between soil organic carbon
content and the DGT-measured availability of Tc (TcDGT) at short (3-100 days)
and longer (549 days) periods of aging.
• Resupply of Tc from the soil solid phase was very slow at both short and long
periods of aging and did not appear to be governed by any particular soil
property.
• Aging in all soils could be described particularly well by a pseudo-second-order
equation as given by:
𝑄𝑡 =𝑡
1𝑘
𝑄𝑒2 +𝑡𝑄𝑒
where Qt is availability at time t (days), Qe is availability at equilibrium (where
aging is negligible) and k is the pseudo-second-order rate constant (synonymous
to the aging rate constant).
• The pseudo-second-order rate constant (k) was found to be positively
correlated (R2 = 0.5) with soil organic carbon.
• DGT was found to be unsuitable for the measurement of Se in soils of higher
alkalinity (> 10 mM HCO3-). DGT uptake of selenate (SeO4
2-) and selenite
(SeO32-) anions was suppressed due to competition with bicarbonate (HCO3
-)
anions.
• A highly significant relationship (p < 0.01) was observed between soil organic
carbon and the DGT-measured availability of Se (SeDGT) at shorter periods of
aging (3 – 100 days). A significant relationship ( p < 0.05) was observed with
the total Al + Fe content of the soil over the same time period.
• Resupply of Se from the soil solid phase was generally very slow and appeared
to be controlled by the soil organic carbon.
• The pseudo-second-order aging rate constant was found to be positively
correlated with both organic carbon (R2 = 0.49) and total Al + Fe (R2 = 0.76).
Figure 3. DGT-measured availability of Tc in all 20 incubated soils over 549 days aging after normalising each time point to day three. Soils are highlighted according to organic carbon content.
Figure 4. DGT-measured availability of Se in nine incubated soils over 549 days aging after normalising each time point to day three. Soils with an alkalinity > 10 mM HCO3
- are omitted. All soils are highlighted according to organic carbon content and texture.
> 4%% organic C: < 4% 4 - 8%
> 4%% organic C: < 4% 4 - 8%