Airbrush Laser PointerType Fixing at Cup

Model Babette

User's Manual

Please Read First

Model Babettemodel_babette @ pachelbel . jphttps:pachelbel.jp/model_babette

About Reassembling after Disassembling and Cleaning

Cleaning Method

Expendables

Warranty

！Direct viewing may cause blurred vision.

Mentions

Caution

two AA batteries

About batteries

1

1.

2.

Mounting Method

Laser Pointer Unit

Main UnitSnipe Cap x 2Laser pointer x 2 + Power supply unitHex Wrench (Bold, for hex socket head cap screw)Hex Wrench (Thin, for setscrews)Repeat Binding Tie x 2

Battery: Two AA batteriesVoltage: 3VCurrent Consumption: 22mA (Default)Gain: Less than 1mWWavelength: 640~660nmOperating Temperature: -10~40℃Storage Temperature: -30~70℃

・

・

・

・

・

・

・

・

・

・

・

・

・

1.Fit the collar around your hand piece.2. Fix the cup holder to the painting cup of your hand piece.

Fix the wires at your favorite position of the handpiece withbundled repeat binding ties, and align the wires with the air tube.

Cup holder

2

Loosen the knurled screw, and adjust the horizonal angle of the laser pointer.

Loosen the hex socket head cap screw with the hex wrench, and adust the vertical angle of the laser pointer.

Basic Setting Method

1. To Adjust Laser Pointer Direction

2. Basic Focus Adjusting Method

Adjust the laser direction to the center of sprayed paint.

If the laser light is annoying, please set it to a position slightly away from the center and paint with aiming at the center of laser irradiation.

Spray paint to testing target with "proper distance" and "the angle at which the handpiece and the target are perpendicular".

Knurled ScrewAngle Scale Hex Socket Head Cap Screw

1

2

3

3

Set hex nut in the holder. (Please implant it deeply.)Set the holder on the arm and secure with the lnurled screw.Set hex nut on the inside of the main unit. (Please implant it deeply.)Secure the one assembled in 1. and 2. to the main unit with hex socket head cap screw. (The mounting angle will be adjusted later.)Assemble the other (left ot right) side in the same way as .

1. Attach the Arm and Holder to the Main Unit

Focus of the laser pointer can be adjusted by rotating the tip. Be careful that the spring can be easily dettached if you loosen it too much.Be careful not to over tighten screws. Screw holes might be damaged.

1. Place 4 setscrews at small holes of resin parts.2. Insert the laser pointer into the holder with keeping the board *horizontally*.

Reassembling Method after Disassembling and Cleaning

2. Set Laser Pointer

Keep a board inhorizontal position.

ArmKnurled Screws

Hex Socket Head Cap Screw

Small Hex Nut

Big Hex Nut

Flat Washer

3

1

2

1

4

4～

1

5

32

4

4

Setscrew

Hex Nut

Hex Socket Head Cap Screw

3. Assemble Cup Fixing Parts

Cup Holder

Thank you very much for purchasing an Airbrush Laser Pointer.We apologize if there is an English mistake in the user's manual.

Model Babette

5