www.canbusemulator.com/en

USER MANUAL

+90 530 937 46 36erenakarsubasi

ADBLUE EMULATOR DAF

www.canbusemulator.com/en

Installation

Emulator

For

DAF

Euro

6

DAF EURO 6 ADBLUE CANCEL EMULATOR INSTALLATIONYou must attach the emulator to the rear of the silencer under the EAS ECU.You must first disconnect the NOx sensor cables and connect the emulator cables to the NOx cables.You must obtain fuse F22 (e497, 15A)

CAN cables

are

located

at

the

top

of

the

NOx

socket.

Car

side

Emulator

sideCAN

H

-------------------->

YELLOW

cableCAN

L

-------------------->

GREEN

cablePOWER

(+)

-------------->

RED

cableGND

(-)

------------------->

BLACK

cable

IMPORTANT

NOTE:

Only

the

CAN

cables

are

to

be

connected

from

the

NOx

socket

as

the

truck's

fuse

has

been

taken.

For

power

connections

you

need

to

use

ground

(GND)

and

contact

(+).

You

must

clear

the

error

codes

from

the

engine

ECU.

If

you

do

not

have

DAVIE

software,

you

can

use

DAF

Euro

6

DTC

Eraser.

The

connection

type

DAF460

/

480

is

the

same

but

the

NOx

socket

locations

are

different.

The

following

are

shown.

DAF460

1. Tray type: you must get fuse F22 (e497, 15A)2. Tray type: You should take fuses D25 and D26 (10A and 15A).

Daf vehicles have two types of fuse plates, which are illustrated below. Which type of vehicle If there is a fuse tray, follow the instructions.

muratRectangle

www.canbusemulator.com/en

Installation

Emulator

For

DAF

Euro

6

DAF480

1.Tab type fuse

www.canbusemulator.com/en

Installation

Emulator

For

DAF

Euro

6

1. Tray type fuse

If this fuse plate is installed in your vehicle, remove fuse D25 and D26.Connect the positive (+) line of the emulator to the contact line.