ROLLOVER CRASHWORTHINESS

ACRS Policy Position

A rollover crashworthiness standard needs to be urgently developed and adopted. The rollover crashworthiness for all passenger vehicles driven in Australia (sedan, wagon, 4WD and MPVs) should be assessed according to the standard and clearly indicated.

Objective

To improve the intrinsic safety of passenger vehicles and thus reduce the consequences of driver error and road hazards.

To support and encourage the development and adoption of a rollover crashworthiness performance test procedure.

To promote correct understanding of the risks and benefits of purchasing a vehicle with a reduced rollover crashworthiness performance.

Discussion

Rollover crashes account for approximately 22% of passenger cars in fatal crashes in Australia [1] and yet only represent approximately 10% of fatal road crashes. Rechnitzer et al.[2] reported on an Australian based study of rollover, using 1988 Federal Office of Road Safety (FORS) Fatality File data that rollovers; "constitute 19% of occupant fatalities in Australia." The problem of rollover is magnified further when vehicles are operated in a non-urban environment. Rechnitzer et al. reported that; "rollover crashes are a common cause of occupant injury especially on non-urban roads. They constitute to 44% of occupant fatalities in rural Western Australia and 54% in rural Northern Territory"

Henderson and Paine1 reported on an Australian based for FORS, using 1988, 1990 and 1992 FORS Fatality File data that; "rollover crashes, especially in the country, are usually very destructive events. About 15% of passenger cars in fatal crashes in Australia have overturned. Between about 13% and 16% of all passenger-car occupants killed in Australia died primary as a result of injuries received in a rollover."

Vehicle rollovers remain one of the major crash types yet to be dealt with in terms of effective vehicle design countermeasures and performance standards. This is despite the progress in understanding how rollovers occur, increased knowledge of vehicle handling technology, the development of occupant protection measures, sophisticated crash modelling software, and greatly improved injury and crash testing measurement laboratory systems. Although crash prevention is the preferred countermeasure for all crash types, this is particularly true for rollovers. Whereas for most crashes serious or fatal injury outcomes are typically related to crash severity, this is less true for rollovers where fatal or serious injuries can still occur in low energy rollover events due to partial occupant ejection.

It is imperative that Australia begins to develop a test procedure for assessing rollover crashworthiness. A methodology for testing and ranking rollover crashworthiness has been proposed by Richardson et al[3] and is

PO Box 198, MAWSON, ACT 2607 Ph: (02) 6290 2509 Fax: (02) 6290 0914

Email: eo@acrs.org.au www.acrs.org.au ABN: 12 841 412 581

Patron: Her Excellency Ms Quentin Bryce AC Governor-General of the Commonwealth of Australia

Fostering communication, networking, professionalism & advocacy in road safety

being implemented in Australia by fleet owners who are at particular risk of rollover crashes. A methodology needs to be urgently adopted for all vehicles driven in Australia.

The importance of rollover prevention has been recognized in the USA, in particular, where some 10,000 fatalities per annum occur due to rollovers. However, neither the USA (or Europe) have adopted any rollover crashworthiness performance test procedures despite the technology that can be used to protect occupants in such events, i.e. seat belt pretensioners, air bag curtains and rollover sensors. Australia needs to take the lead and develop a world leading performance rollover crashworthiness test procedure.

References:

[1] Henderson M. and Paine M. (1997) Passenger Car Roof Crush Strength Requirements, Report No CR 176, Department of Transport and Regional Services, Federeal Office of Road Safety, Canberra, Australia.

[2] Rechnitzer G.and Lane J., Monash University Accident Research Centre, G.Scott, VicRoads, Rollover Crash Study – Vehicle Design and Occupant Injuries, 15th ESV, 96-S5-O-10.

[3] Richardson S.A., Grzebieta R.H. and Rechnitzer G., Proposal for a Dynamic Rollover Protective System Test, Proceedings ICRASH2002, 3rd International Crashworthiness Conference, ed. Grzebieta R.H. and Chirwa E.C., Society of Automotive Engineers Australia, Melbourne, February 2002.

PO Box 198, MAWSON, ACT 2607 Ph: (02) 6290 2509 Fax: (02) 6290 0914

Email: eo@acrs.org.au www.acrs.org.au ABN: 12 841 412 581