7/23/2019 Acceptable Design for Unequal Wall Thickness

1/3

8/17/2015 Acceptable Design for Unequal Wall Thickness

http://www.wermac.org/documents/unequal_wallthickness.html

home sitemap about abbreviations fun question conversion advertising copyright relax conta

EXPLOREthe WORLDof PIPINGDOCS MATL SOCY PIPES FLANGES FTTG VALVES BOLTS GASKETS EQPT SPECIALS STEEL DIN STEAM OTHERS

Weld End Preparation at Unequal Wall Thicknesses

Acceptable Design in Piping components

In most piping systems there are components such as valves, castings, heavier header sections, and

equipment nozzles which are welded to the pipe.

In such instances the heavier sections are machined to match the lighter pipe wall and the excess

thickness tapered both internally and externally to form a transition zone.

Limits imposed by the various codes for this transition zone are fairly uniform.

The external surface of the heavier component is tapered at an angle of 30 maximum for a minimum

length equal to 1.1/2 times the pipe minimum wall thickness and then at 45 for a minimum of 1.1/2

times the pipe minimum wall.

Internally, either a straight bore followed by a 30 slope or a taper bore at a maximum slope of 1 to 4

for a minimum distance of 2 times the pipe minimum wall are required.

The surface of the weld can also be tapered to accommodate differing thickness. This taper should not

exceed 30. It may be necessary to deposit weld metal to assure that these limits are not violated.

Below some tables with acceptable design for unequal wall thicknesses acc to ASME B31.8

Internal Offset

A

B

T

F

http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/http://void%280%29/mailto:info@wermac.orghttp://www.dewebsite.org/http://www.wermac.org/sitemap/copyright.htmlhttp://www.wermac.org/advertising/advertising.htmlhttp://www.wermac.org/others/convert.htmlhttp://www.wermac.org/others/question_and_answer.htmlhttp://www.wermac.org/others/piping_fun.htmlhttp://www.wermac.org/others/whatismeantby.htmlhttp://www.wermac.org/sitemap/about.htmlhttp://www.wermac.org/sitemap/overview.htmlhttp://www.wermac.org/sitemap/wermac.html

7/23/2019 Acceptable Design for Unequal Wall Thickness

2/3

8/17/2015 Acceptable Design for Unequal Wall Thickness

http://www.wermac.org/documents/unequal_wallthickness.html

C

D

External Offset

E

F

7/23/2019 Acceptable Design for Unequal Wall Thickness

3/3

8/17/2015 Acceptable Design for Unequal Wall Thickness

http://www.wermac.org/documents/unequal_wallthickness.html

Combination Offset

G

NOTE:

(1)No minimum when materials joined have equal specified minimum yield strengths .

Werner Slken 2008 - 2015. All rights reserved.

Do not worry about your difficulties in Mathematics. I can assure you mine are still greater. Albert Einstein