Abacus Training eLearning Plans - NSW and QLD Owner Builder 2020-02-05آ  Abacus Training eLearning...

download Abacus Training eLearning Plans - NSW and QLD Owner Builder 2020-02-05آ  Abacus Training eLearning Plans

of 6

  • date post

    27-Apr-2020
  • Category

    Documents

  • view

    1
  • download

    0

Embed Size (px)

Transcript of Abacus Training eLearning Plans - NSW and QLD Owner Builder 2020-02-05آ  Abacus Training eLearning...

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 1

    PLAN READING QUESTIONS

    Plan Reading & Interpretation Instructions We suggest you print out the 6 pages as follows:

    1. Instructions sheet 2. Instructions sheet 3. Plan View 4. Elevations 5. Sectional Elevation 6. Detail Section & Site Map

    This will enable you to work comfortably with your answers to the Plan Reading Interpretation and Estimating segment of your course. Please read you instruction sheets carefully and ensure you understand the task as requested. Please note: Should you have any difficulty answering any of the questions, you should our office for assistance. rick.heaton@ownerbuildercourses.com This segment of the course has a value of 40% of the total mark and all questions must be answered. Do not read too much into the questions, we are not trying to qualify you as estimators or draftspersons. Get ‘rough’ estimates of the required quantities then match your findings against the responses provided. Do not allow for the ‘portico’ in your answers and only consider the straight drops for each downpipe.

    mailto:rick.heaton@ownerbuildercourses.com�

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 2

    ESTIMATING QUESTIONS

    Instructions

    From the plans provided you are to “take off” (determine) the roofing estimate; to supply and fix as per the rates shown.

    READ MEASUREMENTS ONLY, DO NOT SCALE. Roofing material and ancillaries to be colour matched throughout. Roofing products will be of “Colorbond” Custom Orb – profile, all accessories will be of Blue Scope manufacture as applicable. Colour to be advised.

    Working Sheet Item Description Unit Qty Rate Cost

    1 Allow roofing covering M2 45.00 2 Allow ridge capping M 20.00 3 Allow barge capping M 17.00 4 Allow facia panelling M 10.00 5 Allow 15mm quad guttering (including accessories)

    M 16.00

    6 Top hat metal battens 40mm M 3.00 7 100 x 75mm Downpipe C/B (including accessories)

    M 16.00

    8 Fixing screws “zip” 45mm C/B allow 10/m2 roof covering

    NO. 0.13

    9 Anti con insulation blanket R2.5 rating – 50mm thickness M2 6.00

    10 Sub Total

    Allow GST 10% GRAND TOTAL

    Do not scale from the drawings, use the measurements indicated on the plans.

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 3

    PLEASE NOTE: The following drawings are not to scale Please refer to measurements only

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 4

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 5

  • Abacus Training eLearning Plans

    Owner Builder Assessment Resources Page 6