8D-AGM DATA SHEET

MODEL: 8D-AGM

VOLTAGE: 12

DIMENSIONS: Inches (mm)

BATTERY: VRLA AGM

COLOR: Black (case/cover)

MATERIAL: ABS

WATERING SYSTEM: N/A

OPERATIONAL DATA

Operating Temperature Self Discharge

-4°F to 131°F (-20°C to +55°C). At temperatures below 32°F (0°C) maintain a state of charge greater than 60%.

Less than 3% per month depending on storage temperature conditions.

CHARGING TEMPERATURE COMPENSATION

028 VPC for every 10°F (5.55°C) above or below 77°F (25°C)

add .028 VPC for every 10°F (5.55°C) below 77°F and subtract .028 VPC for every 10°C above 77°F

PRODUCT SPECIFICATIONS

BCI GROUP

SIZETYPE

CAPACITY A Minutes

CRANKINGPerformance CAPACITY B Amp-Hours (AH) ENERGY

(kWh) TERMINAL Type G

DIMENSIONS C Inches (mm)WEIGHT lbs. (kg)

@25 Amps C.C.A. D@0°F

C.A. E@32°F 5-Hr Rate 10-Hr Rate 20-Hr Rate 100-Hr Rate 100-Hr Rate Length Width Height F

12 VOLT DUAL PURPOSE AGM BATTERY

8D 8D-AGM 460 1450 1850 179 210 230 254 3.05 6 20.47 (520) 10.64 (270) 9.08 (231) 161 (73)

A. The number of minutes a battery can deliver when discharged at a constant rate at 80°F (27°C) and maintain a voltage above 1.75 V/cell. Capacities are based on peak performance.

B. The amount of amp-hours (AH) a battery can deliver when discharged at a constant rate at 80°F (27°C) for the 20-Hour rate and 86°F (30°C) for the 5-Hour rate and maintain a voltage above 1.75 V/cell. Capacities are based on peak performance.

C. Dimensions are based on nominal size. Dimensions may vary depending on type of handle or terminal. Batteries to be mounted with .5 inches (12.7 mm) spacing minimum.

D. C.C.A. (Cold Cranking Amps) - the discharge load in amperes which a new, fully charged battery can maintain for 30 seconds at 0°F at a voltage above 1.2 V/cell.

E. C.A. (Cranking Amps) - the discharge load in amperes which a new, fully charged battery can maintain for 30 seconds at 32°F at a voltage above 1.2 V/cell. This is sometimes referred to as marine cranking amps @ 32°F or M.C.A. @ 32°F.

F. Dimensions taken from bottom of the battery to the highest point on the battery. Heights may vary depending on type of terminal.

G. Terminal images are representative only.Trojan’s battery testing procedures adhere to both BCI and IEC test standards.

CHARGING INSTRUCTIONS

CHARGER VOLTAGE SETTINGS (AT 77°F/25°C)

System Voltage 12V 24V 36V 48V

Daily Charge 14.1 – 14.7 28.2 – 29.4 42.3 – 44.1 56.4 – 58.8

Float 13.5 27 40.5 54

Do not install or charge batteries in a sealed or non-ventilated compartment. Constant under or overcharging will damage the battery and shorten its life as with any battery.

TERMINAL CONFIGURATIONS

6 DT Automotive Post & Stud Terminal

Terminal Height Inches (mm) .79 (20)

Torque Values in-lb (Nm) Stud: 95 –105 (11 – 12)AP: 50 – 70 (6 – 8)

Bolt Size 5/16”

For a Trojan Master Distributor near you, call 800.423.6569 or + 1.562.236.3000 or visit www.trojanbattery.com12380 Clark Street, Santa Fe Springs, CA 90670 • USA

Trojan batteries are available worldwide through Trojan’s Master Distributor Network.We offer outstanding technical support, provided by full-time application engineers.

© 2015 Trojan Battery Company. All rights reserved. Trojan Battery Company is not liable for damages that may result from any information provided in or omitted from this publication, under any circumstances. Trojan Battery Company reserves the right to make adjustments to this publication at any time, without notices or obligation. Please check the Trojan Battery website (www.trojanBattery.com) for the most up-to-date information.

TRJN_8D

-AGM

_DS _2015_0518

8D-AGM DATA SHEETBATTERY DIMENSIONS (shown with DT)

TROJAN 8D-AGM PERFORMANCE PERCENT CAPACITY VS. TEMPERATURE

Percent of Available Capacity

Tem

pera

ture

(F)

Tem

pera

ture

(C)

60%40%20%0% 80% 100% 120%

140

120

100

80

60

40

20

0

-20

-40

50

60

40

30

20

10

0

-10

-20

-30

-40

20.47 (520)LENGTH

7.99 (203)

9.08 (231)HEIGHT

10.64 (270)WIDTH

Trojan’s battery testing procedures adhere to BCI-05 (Rev Oct 09) and IEC 61427 test standards.