7.62x 51 SSP Subsonic Penetrator

Provides superior accuracy, stealth and penetration capability

McLean, VA USA

Typical Problems with Subsonic Ammo

• Significantly limited effective range, often less than 200 yards• Limited penetration capability, due to reduced velocity and terminal

energy• Weapon jamming/ failure to cycle, due to lower gas pressures• Reduced accuracy, due to reduced chance of a ‘clean burn’ and

velocity variation• Increased weapon fouling• Increased chance of projectile obstructing, due to lower pressure

DSG’s SSP -Subsonic Penetrator solves these issues

Introducing the 7.62x51-SSP (Subsonic Penetrator)

The SSP provides military and LE agencies new and innovative subsonic capabilities

• Reliable Source:– Developed and tested in Norway– Manufactured in the USA (Idaho)

• Maximum effective range: 600m• Highly effective materiel and armor penetration• Low angle penetration• Accuracy: 1.4MOA-Non Optimized• Normal weapon function and cycling• Exceptional cross-wind stability

Solution

Specifications-(7.62x 51 SSP Subsonic Penetrator)

Bullet weight, gram 19.25 ± 0.05 (297grain)

Ammunition weight, gram 31.5 (486 grain)

Ammunition length, mm 70.6 (2 25/32 In)

Barrel length, mm 560 (22 In)

Velocity (V);

energy (Е);

flight time (T);

trajectory (Y)

and

drop (Z)

at range (Х)

Х V Е T Y Y Y Z

m m/seс Joulе seс m m m m

0330.0-

1082 ft/sec1045

0 0 0 0 0

50 324.4 1010 0.15 + 0.12 + 0.36 + 0.60 + 0.005

100319.9-

1049 ft/sec

982

724 KE

0.31 ZERO + 0.48 + 0.97 + 0.01

150 315.7 957 0.47 – 0.36 + 0.36 + 1.11 + 0.02

200311.8

1023 ft/sec

933

688 KE

0.62 – 0.96 ZERO + 0.99 + 0.04

250 307.9 910 0.79 – 1.81 – 0.61 + 0.62 + 0.06

300304.0

997 ft/sec

887

654 KE

0.95 – 2.92 – 1.49 ZERO + 0.09

350 300.2 865 1.12 – 4.30 – 2.62 – 0.89 + 0.12

400 296.5 844 1.28 – 5.95 – 4.03 – 2.05 + 0.16

450 292.9 824 1.45 – 7.87 – 5.72 –3.49 + 0.20

500 289.2 803 1.62 – 10.09 – 7.69 – 5.22 + 0.25

550 285.5 782 1.80 – 12.59 – 9.96 – 7.24 + 0.30

600281.8

921 ft/sec762

1.98 – 15.40 – 12.53– 9.56

+ 0.36

Penetrated range of 8mm steel plate 100 – 150 m (109-164 yards)

Penetrated range of 6mm steel plate 450 – 550 m (492-601 yards)

Penetrated range of 6mm/600 steel plate 250 – 300 m (273-328 yards)

Penetrated range of 5mm/450 steel plate 100 – 150 m

Weapon Function Test

Weapon: AR-10 with a suppressorResults: Normal weapon function and cycling using the SSP subsonic ammunition

Tested with the Dragon-1Modular Suppressor

Tested with the Dragon-1Modular Suppressor

Technology / Product

• Modular lightweight suppressor

• Monolithic modules, machined from solid bar

• Stainless Steel with inconel baffles

• No moving parts, no welds, highly durable

• Disassemble for inspection or cleaning

• Q-Lock (Quick Release/Mounting – one hand) operation

• Customizable and mission-specific

• Compatible with 3rd party flash hiders

Improved Barrels & Suppressors

The So What

• No moving parts ensure fail-safe operation, even in tough conditions. No welds to break.• Single handed patented Quick Release/Mounting , , , saves time and reduces operational risk• Modular design enables mission-specific version, to suit specific requirements of size, weight and performance.• Better suppressor performance, extended life, ease of use, enhanced value for money through modular , design.

• Current TRL level 9• Projected price in quantity 1000-1200USD• Suppressor is available for T&E now • Weapon-specific variants subject to demand

Accuracy Test

Weapon: Remington and AR-10Ammo: 7.62 SSP

Suppressor: Dragon-1 Range: 300 meters

7.62 SSP at 300 meters7.62 SSP at 300 meters

300m range, 1.4 MOA Pre-production

• Weapon: Remington 700 rifle– Barrel length 26" – Range: 300 meters– Angle: 60 degree

• Results:– Dispersion of five 7.62 SSP bullets: (A) 11.5 cm (4.5 in)– Accuracy: 1.4MOA.

300m, 2.4MOA – Pre-production

• Weapon: AR-10 – Barrel length 24" – 7.62 SSP Subsonic ammo– Range: 300 meters– Angle: 60 degree

• Results:– Dispersion of five ×3 lots 7.62 SSP subsonic bullets: (B, C and D) 18 - 20

cm (7-7.8 in) – Accuracy: 2.4MOA

Penetration Test- 90 deg

NOTE: 8-mm, 6-mm, 5mm and 4mm steel S355MC with tensile strength Rm=355-550 MPa used in all tests.

6mm steel, 90 degree, 600m

• Weapon: Remington

– Range: 600m– Angle: 90 degree– Velocity at impact: 295 m/s - (977 ft/sec)

• Results– Projectile penetrated 6mm steel plate, plus 2mm aluminum plate– Projectile did not break after penetration of 6-mm steel – see the

photo of 2-mm aluminum plate, placed behind steel target.

The subsonic bullet penetrated 6mm steel plate at 600m range.

8mm steel, 90 degree, 150m

• Weapon: AR-10– Range: 150m– Angle: 90 degree– Velocity at Impact: 321 m/s- (1053 ft/sec)

• Results– Bullet can penetrate 8mm steel plate “S355MC” – Bullets before and after penetration of 8-mm steel:

• (A) projectile before shot• (B) two 7.62 SSP projectiles after penetration of 8mm steel

(Steel plate S355MC)

Inclined Target Penetration Test

NOTE: 8mm, 6mm, 5mm and 4mm steel S355MC with tensile strength Rm=355-550 MPa used in all tests.

8mm steel, 60 deg, 300 meters

• Weapon: Remington 700 rifle– Barrel length 26" – Range: 300 meters– Angle: 60 degree

• Results:– Several 7.62 SSP penetrated 8mm steel plate set at 600 angle at 300 meters

6mm steel, 60 deg, 300m

• Weapon: AR-10 – Barrel length 24" – 7.62 SSP Subsonic ammo– Range: 300 meter– Angle: 60 degree

• Results:– All fifteen 7.62 SSP rounds penetrated the 6mm steel plate at 600 angle at 300 meters

Windshield Test

Windshield, 30 deg, 350m – 7.62 SSP

• Weapon: AR-10– The windshield (A) was set at an 30.90 angle for the first shot.– Velocity at the impact in windshield: 300 m/s-(984 ft/sec)– Range: 350 meters

• Results– No change in projectile trajectory, however projectile tumbled after

impacting windshield and struck 5mm steel plate (B) then ricocheted back into windshield (C).

Windshield shot: 29.5 deg, at 50 meters

• Weapon: AR-10– The windshield (E) was set at an 29.50 angle– Velocity at the impact in windshield: 320 m/s- (1049 ft/sec)– Range: 50 meters

• Results:– No change in projectile trajectory, tumbled after impacting windshield and struck 5mm steel witness plate

sideways (F) then ricocheted back into windshield (G).– D0 – 7.62 SSP projectile before firing;

– D1 – first shot into windshield;

– D2 – second shot into windshield;

– D3 – third shot into windshield;

Windshield shot: 29.5 deg, at 50 meters

• Weapon: AR-10– The windshield (E) was set at an 29.50 angle– Velocity at the impact in windshield: 320 m/s- (1049 ft/sec)– Range: 50 meters

• Results:– No change in projectile trajectory, tumbled after impacting windshield and struck 5mm steel witness plate

sideways (F) then ricocheted back into windshield (G).– D0 – 7.62 SSP projectile before firing;

– D1 – first shot into windshield;

– D2 – second shot into windshield;

– D3 – third shot into windshield;

Windshield, compound angle shot: 45 deg (H), 35 deg (V), at 200 meters

• Weapon: AR-10– The windshield (H) was set at 350 and 42.20 angle for third shot. – Projectile velocity at impact in windshield was 312 m/s (1023 ft/sec) at

200meters

• Results– Projectile trajectory did not change, however projectile broke into 2

fragments after impacting windshield. • Two fragments penetrated 4mm + 2mm aluminum witness plates (K).

Car Door Test

Car door, 43 deg, at 100m range

• Target:– Car-door (L) – Angle: 42.90 – Range: 100 meters– Velocity at impact in windscreen: 319 m/s.

(1046 ft/sec)

• Weapon: AR-10

• Results:– No change in projectile trajectory, however projectile “key holed” after penetration of door (L and

M) and tumbled after striking 5mm steel (P)

Available Calibers

• 7.62mm (7.62x51)• 300 Blackout

– Pre-production – Samples available for testing

• 5.56mm (5.56x45)– Currently testing – Samples available for testing

• .50 and .338 – Under development

Thank you.

For more information, please contact:sg@inter2t.com * 703-929-0595

McLean, VA 22101