7402 K598 Pedestal Sign Holder - NCRonlinehelp.ncr.com/Kits/PDF/7402/7402-K598.pdf · 1...
Transcript of 7402 K598 Pedestal Sign Holder - NCRonlinehelp.ncr.com/Kits/PDF/7402/7402-K598.pdf · 1...
7402‐K598
Pedestal Sign Holder Kit Instructions
Issue A
ii
Revision Record Issue Date Remarks
A Apr 2009 First issue
1
Introduction This kit provides a channel to hold an information sign on the either side of the 2336-K052 or 7409-K055 floor pedestals.
Note: Two channels (two kits) can be used to support a full wrap-around sign.
27612
EP42 Sign Channel497-0455963
Thumbscrew, 8-32 x 7/16,Knurled w/Shoulder006-8612853
Screw, #8 x 3/4", Phillips, Flat Hd, Sheet Metal006-8613036
2
Installation Procedures (2336-K052 Pedestal) 1. Install the grommets (5) into the square holes on the side of the pedestal.
2. Secure the Sign Channel to the pedestal with screws (5).
3. Insert the sign into the bracket and secure it with the thumbscrews.
27613
Full Wrap-Around Sign Two channels can be used if it is desirable to install a sign that wraps around the pedestal.
1. Install a Sign Channel on each side of the pedestal as discussed above.
2. Insert the sign into the brackets and secure it with the thumbscrews.
27615
3
Dimensions Use the dimensions below to create the full wrap-around sign. The sign can have a maximum thickness of 11 mm (0.45 in.). The thumbscrews that secure the sign are spaced 305 mm (12 in.) apart.
27617
210 mm(8.25 in.)
1290 mm(50.75 in.)
9.7 mm(0.38 in.)
13 mm(0.5 in.)
Sign Inside Dimensions Channel Dimensions Thumbscrew Spacing
305 mm(12.0 in.)
610 mm(24.0 in.)
915 mm(36.0 in.)
1220 mm(48.0 in.)
4
Installation Procedures (7409-K055 Pedestal) 1. Install the grommets (5) into the square holes on the side of the pedestal.
2. Secure the Sign Channel to the pedestal with screws (5).
3. Insert the sign into the bracket and secure it with the thumbscrews.
27619
Full Wrap-Around Sign Two channels can be used if it is desirable to install a sign that wraps around the pedestal.
1. Install a Sign Channel on each side of the pedestal as discussed above.
2. Insert the sign into the brackets and secure it with the thumbscrews.
27614
5
Dimensions Use the dimensions below to create the full wrap-around sign. The sign can have a maximum thickness of 11 mm (0.45 in.). The thumbscrews that secure the sign are spaced 305 mm (12 in.) apart.
27618
363 mm(14.3 in.)
1290 mm(50.75 in.)
9.7 mm(0.38 in.)
13 mm(0.5 in.)
Sign Inside Dimensions Channel Dimensions Thumbscrew Spacing
305 mm(12.0 in.)
610 mm(24.0 in.)
915 mm(36.0 in.)
1220 mm(48.0 in.)