6.1: Solid Shapes
description
Transcript of 6.1: Solid Shapes
04/22/23 6.1: Solid Shapes
6.1: Solid ShapesExpectation:G2.2.1: Identify or sketch a possible three-dimensional figure, given two-dimensional views (e.g., nets, multiple views). Create a two-dimensional representation of a three-dimensional figure.
04/22/23 6.1: Solid Shapes
Isometric Drawing
An isometric drawing is a drawing in which the horizontal lines of the object are drawn at 30° angles to the horizontal. This gives us the appearance of 3 dimensions.
04/22/23 6.1: Solid Shapes
Isometric Drawing
30º30º
04/22/23 6.1: Solid Shapes
Draw a cube on isometric dot paper.
04/22/23 6.1: Solid Shapes
For edges that exist but cannot be seen, we draw dashed lines. These dashed lines are called hidden lines.
04/22/23 6.1: Solid Shapes
Make an isometric drawing of a stack of cubes that is 3 cubes tall.
04/22/23 6.1: Solid Shapes
Complete Activity #1 on page 373 (first 2 drawings in #1 & 2).
Complete Activity #2 on pages 373.
04/22/23 6.1: Solid Shapes
Orthographic Projections
Orthographic projections are views of an object in a direction perpendicular to the plane of the object.
04/22/23 6.1: Solid Shapes
Orthographic Views
There are 6 basic orthographic projection views:
front, back, top, bottom, right and left side views
04/22/23 6.1: Solid Shapes
Draw the six basic orthographic projection views of the figure below.
04/22/23 6.1: Solid Shapes
Draw the six basic orthographic projection views of the figure below.
04/22/23 6.1: Solid Shapes
Draw the 6 orthographic projection views of the figure below. What are the volume and surface area of the figure?
04/22/23 6.1: Solid Shapes
Assignment
pages 375-377, # 12-16 (evens), 21-26 (all), 28,
31-34, 38-43 (except 41)