5376000037-06 BUS BAR GRID MANUAL - Jerr-Dan | Tow …€¦ · bus bar grid user manual $35.00 ......
Transcript of 5376000037-06 BUS BAR GRID MANUAL - Jerr-Dan | Tow …€¦ · bus bar grid user manual $35.00 ......
5-376-000037REV. 6 - 03/08
© 2008 Jerr-Dan Corporation. All Rights Reserved.
BUS BAR GRIDUSER MANUAL
$35.00
1080 Hykes RoadGreencastle, PA 17225Phone (717) 597-7111
www.jerr-dan.com
5-376-000037REV. 6 - 03/08
OperationPage 2
HEAVY DUTY TIRE LIFT
DO NOT EXCEED THE FOLLOWING RATINGS:HDTL SHDTL
Lifting Capacity (Each Arm) .......................... 7,000 lbs. ......... 12,000 lbs.Lifting Capacity (Total)2 ............................... 14,000 lbs. ......... 25,000 lbs.Towing Capacity (Maximum)1 ...................... 80,000 lbs. ......... 80,000 lbs.
1 THE TOWING CAPACITY SHOULD NOT EXCEED THE GROSS COMBINED WEIGHT RATING (GCWR) OF THE TOWING VEHICLE OR 42,000 LBS. (GCW) GROSS COMBINED WEIGHT OF THE TOWED VEHICLE, WHICHEVER IS LOWER.
2 MAXIMUM LIFTING CAPACITY - THE MAXIMUM LOAD THAT CAN BE LIFTED.
1. Slide the tire lift grid onto thecrossbar.
CAUTION:Make sure that the tire lift Gridis installed as shown with thewide flanged plate on top. Theflanges are marked with an "L"for left hand and an "R" for righthand.
2. Install the retaining pin from theback side of the crossbarthrough the grid and crossbarand secure with the pin. Thereare two width positions. One forwider front end lifts and one fornarrower rear end lifts.
WIDE
FLANGED
PLATE
OPERATION
5-376-000037REV. 6 - 03/08
OperationPage 3
3. Insert the round tube into thedesired position in the grid.
4. Install the retaining pin andhairpin.
5. Retract the tube inward to theloading position.
6. Slide the arm weldment over theend of the grid and adjust to thedesired position for loading.
5-376-000037REV. 6 - 03/08
OperationPage 4
7. Install the retaining pin throughthe grid and arm weldment andsecure with the pin.
8. Extend the under lift under thecasualty vehicle so that the armmakes contact with the front ofthe tires. At the same timemake sure that you are notgoing to damage any underbody components.
9. Using the pulling tool, extend theround tube to capture the backof the tire. After extending thetube, make sure that the flangededge of the tube is turned up toprevent the tire from sliding offthe end of the tube.
CAUTION:When lifting a vehicle that hasdual tires from the rear, onlyextend the round tube out tocapture the inside tire. Theflanged edge of the tube mustbe between the tires and turnedup to prevent the tire from slidingoff the end of the tube.
5-376-000037REV. 6 - 03/08
OperationPage 5
10. Raise the boom to lift thecasualty vehicle slightly. At thesame time make sure that youare not going to damage anycomponents.
11. Attach the hook end of the tie-down strap to the round tubebehind the tire. Pull the strap upand cover the tire and attach thehook on the ratchet end of thestrap to the arm in front of thetire.
12. Take up the slack in the strapby ratcheting the takeup spoolarm. Continue until the tires showsome compression.
CAUTION:If vehicle to be towed is on aslope, do not release the brakeuntil the load is secured.
5-376-000037REV. 6 - 03/08
OperationPage 6
13. Always secure the steeringwheel with a steering wheel strapfor any front or rear tow.
14. With the vehicle in neutral andthe parking brake released, youcan move the vehicle safely up,down, in or out. All of thesemovements are hydraulicallycontrolled.
15. Power retract the under lift untilthe casualty vehicle is aboutthree (3) to four (4) feet from theback of the recovery vehicle.Leave enough room to maneuveraround corners without cornerbinding or causing contactbetween the two (2) vehicles. Besure that the fly boom isextended at least four (4) in.from the middle boom sectionto ensure unobstructed cross-bar pivoting.
16. Raise the casualty vehicle into towing position observing the far end forsufficient ground clearance. It is possible to set the rear of a front liftedvehicle completely onto the ground, causing damage. Take irregularroad surfaces into consideration.
NOTE:
When towing, the Underlift Boom should be as close to horizontalas possible. You will have better turning and manueveringcapabilities and it will prolong the life of your under lift and pivotpin.
5-376-000037REV. 6 - 03/08
OperationPage 7
17. Be sure to maintain sufficientground clearances with thebottom of the casualty vehicle.
18. Attach the safety chains andauxiliary towing lights.
19. Hook-up and connect air andbraking systems.
20. If the remote hand controller wasused, turn the CONTROL switch“OFF”. (Switch is located onpanel on the floor.)
WARNING:Do not use the tire lift if the tire(s) of the casualty vehicle are flat orif there is damage to the wheels or suspension.
CAUTION:The tire lift and grid tubes must be in their outermost positions forstorage on the under lift when folded up in the travel position toavoid damage to the body.
CAUTION:Retighten the tie-down straps periodically during a tow as the tiressettle into the grid from towing.
5-376-000037REV. 6 - 03/08
OperationPage 8
CAUTION:
The use of secondary tie-down chains is recommended. Fit thesecondary tie-down chains to the axle (not to any part of thesuspension or body which will rise and fall with the suspension)arranged so as to hold the wheel down in the grid and prevent itfrom jumping up, forwards, or backwards. Use load binders asrequired.
CAUTION:The use of trailer brakes or secondary braking devices while towingis recommended.
CAUTION:Do not tow any vehicle without safety chains being installed.
CAUTION:
Always follow the chassis manufacturer's recommended proceduresfor towing. Remove drive lines and drive shafts as directed. Manyvehicles can be severely damaged unless these components areremoved prior to towing.
CAUTION:
All products are subject to age, wear and deterioation, all of whichcause a reduction in the products breaking strength capacity. It isrecommended that all products be regularly inspected. Any worn,deformed, misused or overloaded products should be replacedimmediately.
5-376-000037REV. 6 - 03/08
PartsPage 9
HD
TL
TIR
E L
IFT
ITE
MP
AR
T N
O.
DE
SC
RIP
TIO
NQ
TY
134
8400
0048
Gri
d W
eld
RH
12
3484
0000
49G
rid
We
ld L
H1
330
2000
0120
Arm
We
ld R
H1
430
2000
0119
Arm
We
ld L
H1
539
1200
0038
Tub
e W
eld
26
4691
0002
74P
in2
776
9100
0020
Hai
rpin
28
7691
0000
26H
itchp
in2
976
9100
0021
Hitc
hpin
210
7330
0002
78D
ecal
- C
autio
n2
1173
3000
0277
Dec
al -
Rat
ing
212
7759
0000
04R
ivet
813
3561
0000
08H
oo
k -
2"
414
7894
0000
28R
atc
he
t - 2
"4
1578
9400
0037
Str
ap
- 2
"2
1645
6100
0012
Pu
ll H
oo
k1
PARTS
5-376-000037REV. 6 - 03/08
PartsPage 10
SH
DT
L T
IRE
LIF
T
ITE
MP
AR
T N
O.
DE
SC
RIP
TIO
NQ
TY
134
8400
0073
Gri
d W
eld
RH
12
3484
0000
72G
rid
We
ld L
H1
330
2000
0120
Arm
We
ld R
H1
430
2000
0119
Arm
We
ld L
H1
539
1200
0033
Tub
e W
eld
- 26.
75"
239
1200
0038
Tu
be
We
ld -
23
"2
646
9100
0274
Pin
27
7691
0000
20H
airp
in2
876
9100
0026
Hitc
hpin
29
7691
0000
21H
itchp
in2
1073
3000
0278
Dec
al -
Cau
tion
211
7330
0005
50D
ecal
- R
atin
g2
1277
5900
0004
Riv
et8
1335
6100
0008
Ho
ok
- 2
"4
3561
0000
15*
Ho
ok
- 3
"4
1478
9400
0028
Ra
tch
et -
2"
478
9400
0060
*R
atc
he
t - 3
"4
1578
9400
0037
Str
ap
- 2
"2
7894
0000
57*
Str
ap
- 3
"2
1645
6100
0012
Pu
ll H
oo
k1
* in
clu
de
d in
Str
ap
Ass
em
bly
Kit,
P/N
75
77
00
03
68
5-376-000037REV. 6 - 03/08
PartsPage 11
1
2
3
4
5
5
6
6
7
7
8
8
9
910
10
1112
12 11
13
13
14
14
15
16
TIR
E L
IFT
5-376-000037REV. 6 - 03/08
1080 Hykes RoadGreencastle, PA 17225Phone (717) 597-7111
www.jerr-dan.com