3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978....

16
3CS, FR and Therma-Corn Installation and Operating Manual I & W #07.05.004.00

Transcript of 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978....

Page 1: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

3CS, FR and Therma-CornInstallation

andOperating

ManualI & W #07.05.004.00

Page 2: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 3: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

Therma-Corn FRC-I and FRC-II

Therma-Corn

Page 4: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

This manual provides the installation and operationinstructions for Hatco FR and 3CS heaters and Therma-Corn models FRC-I and FRC-II.

Therma-Corn,

THERMA-CORN, FRC-I, and FRC-IITherma-Corn,

Page 5: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 6: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

Therma-CornTherma-Corn

Therma-Corn

Figure 6. Therma-Corn Model FRC-II

Figure 7. Therma-Corn Model FRC-I

THERMA-CORN

Page 7: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 8: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 9: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 10: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 11: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 12: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

Therma-Corn.

Therma-Corn ModelsSee Figure 9

FR ModelsSee Figure 9

Page 13: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.

Heat up time for 80 ears of corn is approximately 25minutes. The thermostat should be set to hold the water at150°F.

If cobs are removed too soon, corn will not have fullyreconstituted and the kernels will be soft or mushy.

After emptying a basket, refill with forzen corn and placethe basket in the rear of the Therma-Corn. This is importantbecause the water flow in the Therma-Corn is from front toback.

Therma-CornTherma-Corn

Therma-CornTo protect the heater from damage, if the Therma-Corn isto be shipped or stored in freezing temperatures, or if it isnecessary to drain the heater for servicing, follow thedraining procedure under DRAINING HEATER FORSERVICE OR PROTECTION FROM FREEZING.

Page 14: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 15: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.
Page 16: 3CS, FR and Therma-Corn Installation and Operating Manualard Greenlee in. conduit Cutter "500-6978. which is slightly under 2 in. diameter, File or ream holes as neces- saty to 2 in.