3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04...

4
3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ASSEMBLY INSTRUCTIONS IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY THIS ITEM IS INTENDED FOR OUTDOOR DOMESTIC USE ONLY, NOT FORCOMMERCIAL USE For customer service in the US and Canada, call: 1-877-730-1583, 9:00AM - 5:00PM EST, Monday – Friday, English and French spoken, or visit www.proshade.com. NOTE: The Finial (B) contains two lithium batteries (2 x 2200mAh). Do not attempt to open the Finial (B) when in use If batteries are not working properly, please contact customer service to replace the entire finial. Do not attempt to replace the batteries. . Do not use the Umbrella without the Finial (B) properly installed. AC Adapter: Input: 100V~240V AC, Output: 4.2V DC AC adapter can be used for both indoor and outdoor. UL Certification number is: E486164. Solar panel Finial with cap, batteries included Frame with canopy AC Adapter 1

Transcript of 3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04...

Page 1: 3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04 › ... · TO ASSEMBLE THE UMBRELLA Step 1: Remove the cap on the finial (B),

3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ASSEMBLY INSTRUCTIONS

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY THIS ITEM IS INTENDED FOR OUTDOOR DOMESTIC USE ONLY,

NOT FORCOMMERCIAL USE

For customer service in the US and Canada, call: 1-877-730-1583, 9:00AM - 5:00PM EST, Monday – Friday, English and French spoken, or visit www.proshade.com.

NOTE: The Finial (B) contains two lithium batteries (2 x 2200mAh). Do not attempt to open the Finial (B) when in use If batteries are not working properly, please contact customer service to replace the entire finial. Do not attempt to replace the batteries.

. Do not use the Umbrella without the Finial (B) properly installed.

AC Adapter: Input: 100V~240V AC, Output: 4.2V DC AC adapter can be used for both indoor and outdoor. UL Certification number is: E486164.

Solar panel

Finial with cap, batteries included

Frame with canopy

AC Adapter

1

Page 2: 3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04 › ... · TO ASSEMBLE THE UMBRELLA Step 1: Remove the cap on the finial (B),

TO ASSEMBLE THE UMBRELLA

Step 1: Remove the cap on the finial (B), and connect with the solar panel (A). And then attach them to umbrella. Keep the cap for future use.

Step 2: Have the umbrella securely fastened into an umbrella base. (Base not included)

The batteries will be fully charged after 8 hours of sunlight or 5-6 hours using the AC adapter.

MAKE SURE THE LED LIGHTS ARE OFF FOR THE SOLAR PANEL TO RECHARGE THE BATTERY.

CAUTION: YOU MUST CHARGE BATTERY BEFORE FIRST USE . Please note that battery can discharge if they are left unused or uncharged for a long period of time. Failure to charge the battery will result in premature dimming of the lights in your solar umbrella.

OPENCLOSE OPENCLOSE

B

B

A

TO OPEN THE UMBRELLA Before opening your umbrella, gently pull apart and separate the ribs into their natural open position. Pull down the rope until you see the lower hole or upper hole on the tilt, then insert the pin into the hole. At that time, the umbrella is fully open and ready to use.

TO TILT THE UMBRELLA Have the umbrella pole fixed firmly with base and rotate the canopy clockwise or counterclockwise to your desired position. Continue rotating the canopy to move umbrella into its upright position.

2 3

Page 3: 3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04 › ... · TO ASSEMBLE THE UMBRELLA Step 1: Remove the cap on the finial (B),

TO USE LED LIGHTS

NOTE

For everyday normal use, turn the light switch on at night when you want to use the solar light and turn off the switch after use.

Charging port

Switch

Switch

AC Adapter

Charging here

a) The Finial (B) contains two lithium batteries (2 x 2200mAh). To chargethe batteries using the solar panel, press the switch to the off positionduring daylight. Charging time depends on the amount of sunlight; however, at least 8 hours is recommended. b) To charge batteries with the AC adapter, remove the cap on the charging port, connect with the end of AC adapter and then screw together.Charging time is approximately 5~6 hours.c) The AC adapter could be used both indoor and outdoor, while the outdoor plug needs to be covered to prevent water entering when it is in use.d) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) this device must accept any interference received, including interference that may cause undesired operation.

a) The Finial (B) contains two lithium batteries (2 x 2200mAh). To chargethe batteries using the solar panel, press the switch to the off positionduring daylight. Charging time depends on the amount of sunlight; however, at least 8 hours is recommended. b) To charge batteries with the AC adapter, remove the cap on the chargingport, connect with the end of AC adapter and then screw together.Charging time is approximately 5~6 hours.c) The AC adapter could be used both indoor and outdoor, while the outdoorplug needs to be covered to prevent water entering when it is in use.d) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) this device must accept any interference received, including interference that may cause undesired operation.

Switch

Switch

Charging port

TO CLOSE THE UMBRELLA Hold the rope firmly and remove the pin, then release the rope slowly until the umbrella is fully closed. Use tie straps to secure umbrella canopy.

Attention: If the umbrella is stored in a box when not in use, the solar panel and finial must be removed prior to putting the umbrella in the box to avoid damage.

4 5

Page 4: 3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT ... › wp-content › uploads › 2019 › 04 › ... · TO ASSEMBLE THE UMBRELLA Step 1: Remove the cap on the finial (B),

3.36 M / 11 FT ALUMINUM LED MARKET UMBRELLA WITH TILT

Please be advise that the manufacturer provides a two-year warranty that the 3.36m / 11ft Aluminum LED Market Umbrella with Tilt will befree from defects in original materials and workmanship

Frame Frames are warranted to be free from defects in materials and workmanship for a period of two years. Damage to frames due to improper assembly or exposure to water and sub-freezing temperatures is not covered.

Finish The finish is warranted against peeling, cracking, or blistering for a period of two years, provided the unit has not been scratched or abraded. Scratches and chips resulting from abnormal wear and tear are not covered. Fading resulting from exposure to elements is not covered.

Fabric Fabric is warranted for a period of two years against separation at the seams. Fading or discoloration resulting from exposure to the elements, chemicals, or from spills is not covered.

Note: All operation should be according to the instruction manual.

* This warranty DOES NOT COVER the following items: Failure caused by unreasonable or abusive use; failure caused by neglect of reasonable and necessary care; acts of nature (including but not limited to wind, hurricanes, tornadoes, and storms) are not covered by this warranty. The product is not covered by this warranty after two years from the date of purchase.

AUSTRALIA: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

More information at www.proshade.com

CAUTION:The umbrella should be lowered and secured in windy conditions or when not in use. Do not leave open flame or heat sources unattended underneath the umbrella.Do not allow children to remain unattended near the cords that raise the umbrella. Secure the cords that raise the umbrella to underneath of the umbrella (see the figureson page 3 "TO OPEN THE UMBRELLA") in order to prevent fire hazard and/or tostrangulation hazard. Important Information:Umbrella ribs may compress during shipping. To avoid causing permanent damage,read these instructions before using the umbrella.

Care Instruction:Wash umbrella canopy with a mild solution of soap and water. Rinse thoroughly anddrip-dry in an open position. Do not use bleach or solvents on fabric or aluminumframe. Keep closed when not in use. Not recommended for use in patio tables. Ifused in a patio table, always use with an umbrella base and lower in windy conditions.

6 7