Ultra-tec Cable Railing 300 Series Kits For Wood Post

Ultra-tec is Manufactured by:The Cable Connection

Ultra-tec’s Pre-Assembled Cable Railing Kits are manufactured in Carson City, Nevada

International Standards Organization

Made in America

1. Space the cables with a 3” opening between cables2. Support cables vertically every 42”3. Tension the cables to 300-400 lbs

4” Sphere Code Guidelines

1013.3 Opening limitations. Required guards shall not have openings which allow passage of a sphere 4 inches (102 mm) in diameter from the walking surface to the required guard height. 

International Building Code 2009 (Sixth Printing)

Cable Kit Lengths

BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB

First 3 digits represent kit seriesNext 2 digits represent the length of the cableThe -6 represents 3/16” diameter cable

Each 300 Kit Contains

Kit 300 Series for Inside Post to Inside Post

This kit can go through one corner with posts offset on the corner.

Factory Installed Tensioner

Swaging Ferrule is attached to one end of the cable.

Slide the body over the bare end of the cable and over the Ferrule.

Thread the Lag Bolt end into the wood post.

Push-Lock Lag Fixed End

Push-Lock  Lag

300 Kit Installation Instructions Part 1

300 Kit Installation Instructions Part 2