3. AQUA SMARTE PLUS CANNONBALL!™ 90 Pool Awake!™ …...L-shaped key in the system. DO NOT FORCE....
2
3. AQUA SMARTE PLUS CANNONBALL!™ Pool Awake!™ Operation Instructions For Spring Openings READY: Start by removing contaminants to keep water crystal clear SET: Then set your initial chlorine level GO: Then prevent algae with a 90-day algae protection guarantee Aqua Smarte Plus Shine™ Aqua Smarte Plus Optimize™ Aqua Smarte Plus CANNONBALL!™ After using Aqua Smarte Plus Pool Awake!, insert your Aqua Smarte Plus MizerMax Pac for continuous low- chlorine maintenance for weeks at a time. 3. Insert upside down into center of Aqua Smarte Plus Mineral Activator pushing down firmly on key to puncture seal. 1. Turn off pump and turn dial to the lowest setting and remove cap from the Aqua Smarte or Aqua Smarte Plus System. 2. Remove cap from Aqua Smarte Plus CANNONBALL! without removing seal. 4 4. Replace cap by hand only. DO NOT OVER TIGHTEN. Turn control dial to Setting 5. 5. Turn pump on for 90 minutes allowing Aqua Smarte Plus CANNONBALL! to circulate through pool. 6. To remove Aqua Smarte Plus CANNONBALL!, turn pump off, turn dial to lowest setting, remove system cap. 7. Lift Aqua Smarte Plus CANNONBALL! up and allow any water in the container to drain through the system before recycling or discarding in trash. NOTE: If water shows more than a hint of blue inside Aqua Smarte or Aqua Smarte Plus System, replace the cap, turn dial to Setting 5 and run the pump for one minute. 8. If pool size requires additional Aqua Smarte Plus CANNONBALL!, repeat steps 1-7. 553081243R2N 20-48-0262 SHINE “ Eliminates Contaminants for Crystal Clear Water OPTIMIZE ™ Establish an Initial Chlorine Level with Precise Feeding It’s as easy as Ready, Set, Go! King Technology, Inc. 530 11th Ave S, Hopkins, MN 55343 • 952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com (see website below for guarantee details) 90 MIN After Aqua Smarte Plus Shine and Aqua Smarte Plus Optimize have dispensed, test the water before adding Aqua Smarte Plus Cannonball! for a 90-day algae-protection guar- antee. When the pH is between 7.2 and 7.8 and the chlorine level is no more than 4.0 ppm, follow steps 1-8 below. U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095; 6,948,510 and other U.S. and Foreign patents pending. NOTE: Avoid adding other chemicals until this product has been circulated (filtered) for at least 24 hours.
Transcript of 3. AQUA SMARTE PLUS CANNONBALL!™ 90 Pool Awake!™ …...L-shaped key in the system. DO NOT FORCE....
3. AQUA SMARTE PLUS CANNONBALL!™
3. AQUA SMARTE PLUS CANNONBALL!™
Pool Awake!™Operation Instructions
For Spring Openings
READY: Start by removing
contaminants to keep water crystal clear
SET: Then set your initial chlorine
level
GO: Then prevent algae with
a 90-day algae protection guarantee
Aqua Smarte Plus Shine™
Aqua Smarte Plus Optimize™
Aqua Smarte Plus CANNONBALL!™
After using Aqua Smarte Plus Pool Awake!, insert your Aqua Smarte Plus MizerMax Pac for continuous low-chlorine maintenance for weeks at a time.
After using Aqua Smarte Plus Pool Awake!, insert your Aqua Smarte Plus MizerMax Pac for continuous low-chlorine maintenance for weeks at a time.
3. Insert upside down into center of Aqua Smarte Plus Mineral Activator pushing down firmly on key to puncture seal.
3. Insert upside down into center of Aqua Smarte Plus Mineral Activator pushing down firmly on key to puncture seal.
1. Turn off pump and turn dial to the lowest setting and remove cap from the Aqua Smarte or Aqua Smarte Plus System.
2. Remove cap from Aqua Smarte Plus CANNONBALL! without removing seal.
1. Turn off pump and turn dial to the lowest setting and remove cap from the Aqua Smarte or Aqua Smarte Plus System.
2. Remove cap from Aqua Smarte Plus CANNONBALL! without removing seal.
4
4
4. Replace cap by hand only. DO NOT OVER TIGHTEN. Turn control dial to Setting 5.
4. Replace cap by hand only. DO NOT OVER TIGHTEN. Turn control dial to Setting 5.
5. Turn pump on for 90 minutes allowing Aqua Smarte Plus CANNONBALL! to circulate through pool.
6. To remove Aqua Smarte Plus CANNONBALL!, turn pump off, turn dial to lowest setting, remove system cap.
7. Lift Aqua Smarte Plus CANNONBALL! up and allow any water in the container to drain through the system before recycling or discarding in trash.NOTE: If water shows more than a hint of blue inside Aqua Smarte or Aqua Smarte Plus System, replace the cap, turn dial to Setting 5 and run the pump for one minute. 8. If pool size requires additional Aqua Smarte Plus CANNONBALL!, repeat steps 1-7.
5. Turn pump on for 90 minutes allowing Aqua Smarte Plus CANNONBALL! to circulate through pool.
6. To remove Aqua Smarte Plus CANNONBALL!, turn pump off, turn dial to lowest setting, remove system cap.
7. Lift Aqua Smarte Plus CANNONBALL! up and allow any water in the container to drain through the system before recycling or discarding in trash.NOTE: If water shows more than a hint of blue inside Aqua Smarte or Aqua Smarte Plus System, replace the cap, turn dial to Setting 5 and run the pump for one minute. 8. If pool size requires additional Aqua Smarte Plus CANNONBALL!, repeat steps 1-7.
553081243R2N 20-48-0262
553081243R2N 20-48-0262
SHINE “
Eliminates Contaminants for
Crystal Clear Water
OPTIMIZE™
Establish an Initial ChlorineLevel with Precise Feeding
It’s as easy as Ready, Set, Go!
King Technology, Inc.530 11th Ave S, Hopkins, MN 55343 • 952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
Pool Awake!™Operation Instructions
For Spring Openings
READY: Start by removing
contaminants to keep water crystal clear
SET: Then set your initial chlorine
level
GO: Then prevent algae with
a 90-day algae protection guarantee
Aqua Smarte Plus Shine™
Aqua Smarte Plus Optimize™
Aqua Smarte Plus CANNONBALL!™
SHINE “
Eliminates Contaminants for
Crystal Clear Water
OPTIMIZE™
Establish an Initial ChlorineLevel with Precise Feeding
It’s as easy as Ready, Set, Go!
King Technology, Inc.530 11th Ave S, Hopkins, MN 55343 • 952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
(see website below for guarantee details)
(see website below for guarantee details)
90 MIN
90 MIN
After Aqua Smarte Plus Shine and Aqua Smarte Plus Optimize have dispensed, test the water before adding Aqua Smarte Plus Cannonball! for a 90-day algae-protection guar-antee. When the pH is between 7.2 and 7.8 and the chlorine level is no more than 4.0 ppm, follow steps 1-8 below.
After Aqua Smarte Plus Shine and Aqua Smarte Plus Optimize have dispensed, test the water before adding Aqua Smarte Plus Cannonball! for a 90-day algae-protection guar-antee. When the pH is between 7.2 and 7.8 and the chlorine level is no more than 4.0 ppm, follow steps 1-8 below.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095; 6,948,510 and other U.S. and Foreign patents pending.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095; 6,948,510 and other U.S. and Foreign patents pending.
NOTE: Avoid adding other chemicals until this product has been circulated (filtered) for at least 24 hours.
NOTE: Avoid adding other chemicals until this product has been circulated (filtered) for at least 24 hours.
After balancing the pool water and inserting a new Aqua Smarte Plus Mineral Activator, insert Aqua Smarte Plus Shine using steps 1 through 8.
Water Balance GuidelinespH: 7.2 – 7.8Total Alkalinity: 60 – 120 ppmCalcium Hardness: 150 – 400Total Dissolved Solids: <1500Stabilizer: 20 – 80 ppmFree Chlorine: 0.5 – 1.0 ppm
1. With the circulation system off, set control dial to lowest setting and remove the cap to the Aqua Smarte or Aqua Smarte Plus System.
COLOREDCAPS
2. Remove caps from Aqua Smarte Plus Shine with a pliers or other suitable tool.
3. Turn Aqua Smarte Plus Shine over so open ends face down and insert into the center of the Aqua Smarte Plus Mineral Activator. The ends of the pac will align with an L-shaped key in the system. DO NOT FORCE.
4
4. Replace cap on Aqua Smarte or Aqua Smarte Plus System and set dial to Setting 5.
5. Turn on pump and allow 1 hour for the product to slowly dispense into the pool. If after 1 hour, the pac still contains some ingredi-ent, re-insert, replace cap and run the circulation for an additional 30 minutes.
6. Remove the empty Aqua Smarte Plus Shine and discard or recycle.
1. Aqua Smarte Plus Shine™
SHINE™
Eliminates Contaminants for
Crystal Clear Water
SHINE™
Eliminates Contaminants for
Crystal Clear Water
WE RECYCLE
2 3
7. Replace cap on Aqua Smarte or Aqua Smarte Plus System and allow circulation to run at least 15 minutes before inserting any other Aqua Smarte Plus products.
After balancing the pool water and inserting a new Aqua Smarte Plus Mineral Activator, insert Aqua Smarte Plus Shine using steps 1 through 8.
Water Balance GuidelinespH: 7.2 – 7.8Total Alkalinity: 60 – 120 ppmCalcium Hardness: 150 – 400Total Dissolved Solids: <1500Stabilizer: 20 – 80 ppmFree Chlorine: 0.5 – 1.0 ppm
1. With the circulation system off, set control dial to lowest setting and remove the cap to the Aqua Smarte or Aqua Smarte Plus System.
COLOREDCAPS
2. Remove caps from Aqua Smarte Plus Shine with a pliers or other suitable tool.
3. Turn Aqua Smarte Plus Shine over so open ends face down and insert into the center of the Aqua Smarte Plus Mineral Activator. The ends of the pac will align with an L-shaped key in the system. DO NOT FORCE.
4
4. Replace cap on Aqua Smarte or Aqua Smarte Plus System and set dial to Setting 5.
5. Turn on pump and allow 1 hour for the product to slowly dispense into the pool. If after 1 hour, the pac still contains some ingredi-ent, re-insert, replace cap and run the circulation for an additional 30 minutes.
Dispense Aqua Smarte Plus Optimize to establish an initial chlorine level in the pool following the same steps 1 through 8 for Aqua Smarte Plus Shine.
All components are recyclable when finished dispensing.
6. Remove the empty Aqua Smarte Plus Shine and discard or recycle.
1. Aqua Smarte Plus Shine™
2. Aqua Smarte Plus Optimize™
SHINE™
Eliminates Contaminants for
Crystal Clear Water
SHINE™
Eliminates Contaminants for
Crystal Clear Water
WE RECYCLE
2 3
WATER MANAGEMENT SYSTEM
WATER MANAGEMENT SYSTEM
1 HOUR
1 HOUR
8. Repeat steps 1-7 if additional Aqua Smarte Plus Shine is required.
7. Replace cap on Aqua Smarte or Aqua Smarte Plus System and allow circulation to run at least 15 minutes before inserting any other Aqua Smarte Plus products.
Dispense Aqua Smarte Plus Optimize to establish an initial chlorine level in the pool following the same steps 1 through 8 for Aqua Smarte Plus Shine.
All components are recyclable when finished dispensing.
2. Aqua Smarte Plus Optimize™
8. Repeat steps 1-7 if additional Aqua Smarte Plus Shine is required.
