8/13/2019 22404 Riso

1/2

ISSUE DATE:11/9/2006 SUPERSEDES: DATED: PAGE:1 of 2

Copyright:2006 RISO, Inc. All products are trademarks of their respective companies. Specifications subject to change without notice.

SUBJECT RZ2/3 Program Update V2.11

Technical InformationBulletin

APPLIES TO: RZ2xx/3xx Series General Information DOCUMENT NO: 22404

RZ2xx/3xx Program V2.11

The following are descriptions of the program revision 2.11.

DescriptionRZ2 RZ3

O

Revised Test ModeError detection is added for Test Mode #887: print Drum Inking Action. C01-512:

Ink sensor did not go ON even when inking was performed for 45 seconds.

Revised Test Mode

The selection [5] of the setting of print pressure for proof print after master-making has been added. When [5] is set, the print pressure for proof printing is

fixed to the maximum force.

Print pressure setting for proof-read printing

#949/

#950

Setting Range: 1 to 5Unit: 1

[0]: extralight[1]: light

[2]: normal (default)

[3]: dark[4]: extra dark

[5]:maximum pressure

Revised Messages

The descriptions of some ink colors on LCD Display have been changed tomatch the descriptions on the ink bottle and in the Printer Driver.

Added new Test Mode: Duration period of M-M StandbyWhen Master Making is ready, the machine goes into M-M Standby mode to

reduce the first print time and continues M-M Standby for the period. After the

period has past without any machine operation, M-M Standby is cancelled.During M-M Standby, the machine does not print the received data from the PC

until this period has ended. When [0] is selected as the value the job startsimmediately.

Duration period of M-M Standby

#162

Setting Range: 0 to 180 Seconds

Unit: 1[0]: Disable M-M Standby mode

[X]: Set the period for M-M Standby

O

O O

O O

O O

The program version for the RZ series has been changed. The new version, V2.11, is available on the RISO web site

@ http://us.riso.com/dealers/PePsel.asp (login & password required). Within this bulletin you will find changesincorporated in the new RZ program. Please read this bulletin thoroughly to familiarize yourself with the changes.

Depending on which series you have, you will have to use either the OLLM or the OLNM program version.

8/13/2019 22404 Riso

2/2

ISSUE DATE:11/9/2006 SUPERSEDES: DATED: PAGE:2 of 2

Copyright:2006 RISO, Inc. All products are trademarks of their respective companies. Specifications subject to change without notice.

SUBJECT RZ2/3 Program Update V2.11

Technical InformationBulletin

APPLIES TO: RZ2xx/3xx Series General Information DOCUMENT NO: 22404

M-M (Master Making) Standby mode:If the presence of the master on the print drum is confirmed when the original is set, the operations specified

below are performed during standby. If the START key is not pressed within a preset period, pressing theprint-drum release button or Test print key restores the original status.

- Scanner: Shading compensation, auto base control

- TPH: Pressurization- Clamp unit: Release Operation