211-04-1 - Steering Column Shaft — Lower
-
Upload
peloquin1349391 -
Category
Documents
-
view
214 -
download
0
description
Transcript of 211-04-1 - Steering Column Shaft — Lower
-
211-04-1 211-04-1Steering Column
REMOVAL AND INSTALLATION
Steering Column Shaft Lower
Removal and InstallationItem Part Number Description1 W704980 Lower steering column
shaft-to-upper steering CAUTION: Do not allow the steeringcolumn shaft bolt column to rotate while the steering column shaft
2 W704980 Steering column is disconnected or damage to the clockspring cancoupling-to-steering gear bolt result. If there is evidence that the steering
3 W707137 Dash boot bearing nuts (2 column shaft has rotated the clockspring must berequired) removed and recentered. For additional
4 3C662 Lower steering column shaft information, refer to Section 501-20B.
1. With the vehicle in NEUTRAL, position it on ahoist. For additional information, refer toSection 100-02.
2. Remove and discard the lower steering columnshaft-to-upper steering column shaft bolt.
To install, tighten to 25 Nm (18 lb-ft).
3. Remove and discard the steering columncoupling-to-steering gear bolt.
To install, tighten to 25 Nm (18 lb-ft).
Copyright 2006, Ford Motor CompanyLast updated: 6/19/2006 2007 Mustang, Mustang GT 8/2006
-
211-04-2 211-04-2Steering Column
REMOVAL AND INSTALLATION (Continued)
4. Remove the 2 dash boot bearing nuts. 6. Remove the lower steering column shaft.
To install, tighten to 9 Nm (80 lb-in).7. To install, reverse the removal procedure.
5. Collapse the upper steering column shaftslightly and disconnect the coupling from thelower steering column shaft.
2007 Mustang, Mustang GT 8/2006