211-04-1 - Steering Column Coupling
-
Upload
peloquin1349391 -
Category
Documents
-
view
4 -
download
0
description
Transcript of 211-04-1 - Steering Column Coupling
-
211-04-1 211-04-1Steering Column
REMOVAL AND INSTALLATIONSteering Column Coupling
Removal and InstallationItem Part Number Description1 W702600 Lower steering column
shaft-to-steering column CAUTION: Do not allow the steeringcoupling bolt column to rotate while the steering column shaft
2 W704980 Steering column is disconnected or damage to the clockspring cancoupling-to-steering gear bolt result. If there is evidence that the steering
3 W707137 Dash boot bearing nuts (2 column shaft has rotated the clockspring must berequired) removed and recentered. For additional
4 3N725 Steering column coupling information, refer to Section 501-20B.
1. With the vehicle in NEUTRAL, position it on ahoist. For additional information, refer toSection 100-02.
2. Place the steering wheel in the straight-aheadposition and turn the ignition switch to the OFFposition.
3. Remove and discard the lower steering columnshaft-to-steering column coupling bolt. To install, tighten to 47 Nm (35 lb-ft).
Copyright 2006, Ford Motor CompanyLast updated: 6/19/2006 2007 Mustang, Mustang GT 8/2006
-
211-04-2 211-04-2Steering ColumnREMOVAL AND INSTALLATION (Continued)4. Remove and discard the steering column 6. Collapse the upper steering column shaft
coupling-to-steering gear bolt. slightly and disconnect the lower steeringcolumn shaft from the coupling.
To install, tighten to 25 Nm (18 lb-ft).7. Remove the steering column coupling.5. Remove the 2 dash boot bearing nuts.
To install, tighten to 9 Nm (80 lb-in). 8. To install, reverse the removal procedure.
2007 Mustang, Mustang GT 8/2006