2016 02 26 univer power clamps benefits
-
Upload
mitch-yencha -
Category
Automotive
-
view
276 -
download
0
Transcript of 2016 02 26 univer power clamps benefits
AUTOMOTIVE
MANUAL RELEASE BUTTON:It is used to unlock the clamp when it reaches final closing position
Safety unlocking system without air supply
KEY STONE:To protect housings from heavy loads application
Absorbs energy caused by opening/closing movements
OPTICAL SENSOR/UNIVER ORIGINAL DF-U:All metal body
M12 swivel connector
Only one sensor for all clamp and power pivot sizes
Only one sensor for all clamp and power pivot sizes
DETECTION FLAG:Special solution patented by UNIVER with double flag
Mechanical system for high precision signal in opening/closing position
No adjustment required when changing opening angle
connector at 0° connector at 90°
AUTOMOTIVE
AUTOMATIC FLOW CONTROL:
Flow regulator not required
Pneumatic ports on both sides
Possibility to choose Gas or NPT thread
AUTOMOTIVE
STEPLESS ADJUSTMENT OF THE OPENING ANGLE:
Possibility to reduce the opening angle to the minimum required
from 0° to 135°
1 single devicecovers the whole range of possible opening angles STEPLESS
The Sensor recognizes automatic the new angle position reduces stock requirements for the customer.
AUTOMOTIVE
CUSHIONING SYSTEM:
Special solution on piston rod flow regulation allowing, with high loads
ROLLER BEARINGS:Linear and rotary motion guided by roller bearings
AUTOMOTIVE
SPRING PACK:
Ensures positional repeatability
No backlash in closing position
3 million cycles warranty without maintenance
No external stops
AUTOMOTIVE
SPRING PACK:
Possibility to compensate different sheet thicknesses when clamp arm reaches 90° position
Compensating external and internal tolerances
Avoid metal sheet deformation
Different sheets with different thicknesses can be compensated by one clamp
CLAMP SIZE 5 bar operating pressure - MAX METAL SHEET THICKNESS
40 + 1.4mm
50 +1.5 mm
63 +2.0 mm
80 +2.5 mm
PIN CLAMP 5 bar operating pressure - MAX METAL SHEET THICKNESS
50/60 + 1 mm
Metal sheet compensation:
AUTOMOTIVE
CLAMP ARMS:
Standard aluminum (special treatment)
Steel version available
DIN or NAAMS solutions
15 - 25 - 45 - 50 -70 - 75 - 105 - 120 mm offset
light weight
AUTOMOTIVE
Exclusive authorized distributor for Univer North America Automation/Welding Solutions 6620 Cobb DriveSterling Heights, Michigan 48312Tel: (248) 299-0525 / Fax: (248) 299-0528
1-844-8 UNIVER
[email protected] | www.ramsolutions.net