2008 Kawasaki Brute Force - Power Commander
Transcript of 2008 Kawasaki Brute Force - Power Commander
2008 Kawasaki Brute Force - PCIII USB - 1i232-411 www.powercommander.com
2008 Kawasaki Brute Force Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1. Remove the seat and right hand side cover.
2 Locate the 6 pin BLACK connector thatcomes from the throttle bodies.
This connector is located on the right handside of the Quad near the upper frame rail.
Unplug this connector (Fig. A).
3 Plug the PCIII wiring harness in-line of thestock wiring harness and throttle bodyharness (Fig. B).
4 Attach the ground wire from the PCIII to thenegative side of the battery (Fig. C).
Fig.
AFi
g. B
Fig.
C
2008 Kawasaki Brute Force - PCIII USB - 2i232-411 www.powercommander.com
Unplug
Stock connectors
PCIII harness
PCIII connectors
5 Attach the PCIII to the top of the ECU usingthe supplied velcro (Fig. D).
Make sure to clean both surfaces beforeattaching with the alcohol swab.
6 Reinstall side cover and seat.
Fig.
D
2008 Kawasaki Brute Force - PCIII USB - 3i232-411 www.powercommander.com