+12V Constant =

+12v Acc. Switched =

-12V Chassis Ground =

+12V Illumination =

+12V Dimmer =

Amp Remote =

LF+ =

LF- =

RF+ =

RF- =

LR+ =

LR- =

RR+=

Dash Type :

Kit:Harness:Antenna Adapter: MDA-1

Interface Adapter(s): GM09BOnstar w/Bose: GMOS2B11Onstar w/Non-Bose: GMOS210Chime Module: GMCM2B12

About the Vehicle

Make: HUMMER

Model: H2

Year: 2003

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Speaker Adapter : N/A

Factory Assembly: Plastic housing with mounting tabs.

Rear

H2HUMMER

2003

DIN AND A HALF

GM1583

GM06

RR- =

Factory Assembly : Plastic housing with (2) 7mm bolts.

Lower Door : 5 1/4" Midrange

Speaker Sizes

Dimensions:

Dimensions: W= 4 3/4'' L= 4 3/4''D= 4''

NOTES

Rear Door : 5 1/4"Midbass Rear Pillar: 2 1/2''

OPTIONS

ONSTARBOSE PREMIUM SystemCD CHANGER

AMPLIFIER LOCATIONS: Located under the center console.Also the amp is a 6-channel amp.

Aftermarket Kit: SINGLE DIN

W=L= D=

Front Pillar: 1'' Tweeter

NOTES

Speaker adapter fits most 5 1/4'' to 6 1/2''

HUMMER2003 H2

Images

Front Speaker

1. Extract (1) Phillips screw from door handle access area and remove door handle sub-panel.2. Remove Hex screws from behind door handle access panel.3. Use panel removal tool to carefully pry out on panel fasteners to remove panel.4. Press down on tab to unsnap door speaker, unplug and remove.

1. Extract (1) Phillips screw from door handle access area and remove door handle sub-panel.2. Remove Hex screws from behind door handle access panel.3. Use panel removal tool to carefully pry out on panel fasteners to remove panel.4. Extract (3) screws holding speaker, unplug and remove

Radio removal

Front speaker

Rear speaker

1. Open center console storage and extract 4 screws securing hinged lid.2. Remove Torx lock nut holding Shift lever (Nut is facing forward) and Slide shift lever off.3. Use a panel removal tool to carefully pop up cup holder/gear indicator plate.4. Extract (2) 7mm hex screws at bottom of center dash bezel (revealed in previous step).5. Extract (2) 7mm hex screws from center dash bezel (near each vent).6. Carefully pry out on center dash bezel to unsnap, unplug and remove.7. Extract (3) 7mm hex screws holding radio, unplug and remove.

Radio

Rear Speaker

HUMMER2003 H2

Images

Front ''A'' Pillar

Rear ''D'' Pillar1. Use panel removal tool to carefully pry out on panel fasteners to remove panel.2. Unplug speaker and and remove the assembly.

1. Open center console storage and extract (4) screws securing lid. 2. Remove Torx lock nut holding Shift lever (Nut is facing forward) and Slide shift lever off. 3. Use a panel removal tool to carefully pop up cup holder/gear indicator plate 4. Remove 3 screws from rear console trim panel: (1) at top and (2) from recessed area.5. Unplug electrical connectors and remove rear console trim panel.6. Extract (4) screws holding storage bin and remove bin.7. Carfully pull up and remove top console panel.8. Extract (5) bolts holding center console and remove console.

Front ''A'' Pillar

Rear ''D'' Pillar

Center Console

1. Pull away door seal moulding along A pillar trim panel.2. Use a panel tool or flat blade screwdriver to pop out (2) fasteners holding grab handle.3. Use panel removal tool to carefully pry out and release A pillar trim, unplug speaker and remove trim

Center Console