2000-2006 MV Agusta F4 750 - Power Commander · i713-411 2000-2006 MV Agusta 750 - PCIII USB - 1...
Transcript of 2000-2006 MV Agusta F4 750 - Power Commander · i713-411 2000-2006 MV Agusta 750 - PCIII USB - 1...
i713-411 www.powercommander.com 2000-2006 MV Agusta 750 - PCIII USB - 1
2000-2006 MV Agusta F4 750Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Wire tap1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1 Remove the tail section.
2 Remove the fuel tank.
3 Place the PCIII in the tail sectiontemporarily. Route the wiring harnessfrom the PCIII towards the fuel rail.Make sure to go under the subframecrossover by the battery.
4 Disconnect the stock wiring harnessfrom the fuel injector rail (Fig. A).
5 Connect the male end from the PCIIIto the stock female end that you havejust removed from the injector rail.
6 Plug the female end connectors of thePCIII to the injector rail (Fig B).
Align the PCIII connector to the stockwiring harness as shown below. Thesquare edges of the PCIII connectoralign with the spring clip side of thestock wiring harness
7 Disconnect the TPS connector on theright hand end of the throttle bodies.Locate the white wire with the greentracer (Pin “C”) Connect thesupplied wire tap to this wire. Plugthe grey wire from the PCIII to thesupplied wire tap (Fig. C).
Note: It is recommended use dielectricgrease on this connection.
8 Reconnect the TPS connector.
Fig.
AFi
g. B
Fig.
C
i713-411 www.powercommander.com 2000-2006 MV Agusta 750 - PCIII USB - 2
Unplug these connectors
PCIII connectors
Stock connectors
TPS Wire tap
Grey wire from PCIII
PCIIIsquare edges
StockSpring clip
9 Attach the ground wire from thePCIII to the negative side of thebattery (Fig. D).
10 Attach the PCIII to the inner rearfender with the supplied velcro.Make sure to use the suppliedalcohol swab to clean bothsurfaces before attaching.
Fig.
DFi
g. E
i713-411 www.powercommander.com 2000-2006 MV Agusta 750 - PCIII USB - 3