120_CP400+activate+Buzzer
description
Transcript of 120_CP400+activate+Buzzer
-
Title Lang. Rev. Page 54 ABB STOTZ-KONTAKT GmbH CP400 first steps en Q No. o. p. 58
9.4 Activate / deactivate buzzer (continuous beep) In the Control Block Word 2 is a Command Flag Register. Bit 7 is Buzzer Flag, this bit is used to control the operator terminals buzzer. Set the bit to ON (about 1 sec.) to start the buzzer.
In the following example, a maintained button is used to set / reset the Buzzer Flag. Set the Address of the Control Block:
Choose the maintained button and double click on it:
-
Title Lang. Rev. Page 55 ABB STOTZ-KONTAKT GmbH CP400 first steps en Q No. o. p. 58
Set the write address as following:
Name the button of two states:
And there will be a button which activate and deactivate the buzzer: